User's Manual
DLT 300 3.0 Digital Transceiver and DLR 360 3.0 Digital Receiver
12
Programming the Digi-Wave™ System for 2-way Modes
There are 4 basic steps to programming a Digi-wave system:
1. Set Mode: 2-way or 1-way
2. Set Priority: Master 1, Master 2, and Guest
3. Set Address
4. Set Group Number
Most of the programming is done on the DLT(s); the receivers just need to be assigned the correct group number. The Master 1
should be programmed rst - all other units sychronize with the Master 1.
Step 1. Set Mode: 2-way
There are (3) 2-way Modes represented by these symbols on the LCD Display:
2-way:
2-way - Listen only:
2-way - Intercom:
a. With the DLT turned on, press and hold the and buttons until the icons on the display begin ashing.
b. Use either of the the
buttons to scroll through the dierent icon combinations (modes).
c. When you reach 2-way mode, the icon(s) will be ashing (alternately). Go to step 2.
Step 2. Set Priority: Master 1, Master 2, and Guest
a. Push the button to advance to the priority setting.
b. Use either of the the
buttons to scroll through the dierent priorities. Speaker priority is assigned as follows:
1st priority — Master 1 ( M1 ) :
(Must have one per group)
2nd priority — Master 2 ( M2 ) :
(Optional)
3rd priority — Guest ( GST ) :
(All other units in the same group)
c. When you reach the priority you want, go to the next step.
Step 3. Set Address
a. Push the button to advance to the address setting. “ADD” will ash and the current address will be displayed.
b. Use either of the the
buttons to change the address.
c. Each unit must have a dierent (unique) address assigned.
Step 4. Set Group Number
a. Push the button to advance to the group setting. “GROUP” will ash and the current group will be displayed.
b. Use either of the the
buttons to change the group.
c. All units operating together should have the same group number..