User guide

11
switch inside the battery compartment is set to NiMH before
charging. See FIG 4.
2. Insert headphone, earphone or neck-
loop into the stereo output jack.
3. Turn receiver on by turning up
the volume control. The green
power LED will turn on.
4. Press the Channel Seek but-
ton inside the battery compart-
ment once to seek an active
transmitter. See FIG 4. If more
than one transmitter is being used,
you will need to push the seek button
additional times until you locate the signal
you want to hear. The receiver will retain the channel setting
when the unit is turned off.
5. To lock or unlock a selected channel, turn the power off.
While holding the seek button, turn the power back on. When
locked,the receiver will remain on the current channel, regardless
of channel seek button presses.
LED FLASH CODES
Light Code Indicates Description
1 blink Channel locked Seek press remains
on current channel
2 blinks Channel unlocked Seek press tunes to
next channel present
3 blinks Channel unlocked; no
other channels present
Seek press atempts to
find another channel
On-Off-On-Off...
(continuous)
Batteries are low Batteries need to be
replaced or recharged
Fade-on, Fade-off...
(continuous)
No transmitter present
on current channel
Sleep/Power Save mode
(extends battery life)
FIG 4
A
A
AA
+
+
C
hannel
Seek