User guide

6
have any questions.
þ
STEP 3: CONNECT THE POWER
Locate the TFP036 power supply cord equipped with the 5-pin
DIN connector, then plug the connector into the “Power In” jack
located in the back of the T27. Plug the power supply into the
AC outlet. On power up, the number “8” will scroll across the
T27 display while the system initializes. The system will then
display the default system frequency (72.9 MHz)
or the last
selected frequency set by the user.
þ
STEP 4: SELECT THE FREQUENCY
The T27 has 17 available channels in the 72-76 MHz band. By
default, the T27 frequency is set to 72.9 MHz. To change the
frequency on the T27, press and release the down “
q” or
up “
p” frequency selector button until the desired frequency is
displayed. After 3 seconds, the frequency selection will be set,
and the audio will begin transmitting on the new frequency.
NOTE: You can LOCK this selection to prevent others from
accidently changing the frequency.
To LOCK the desired frequency, press and hold both down “q ”
and up “p” frequency selector buttons for 3 seconds until the
word “Loc” appears on the display. The frequency is now locked.
Should the user press the frequency selector button while in
“Lock” mode, the word “Loc” will be displayed for 2 seconds.
To UNLOCK the desired frequency, press and hold both
down “q ” and up “p” frequency selector buttons for 3 seconds
until the transmitter displays ”Un” then “Loc” on the display.
The frequency is now unlocked. The user is now free to change
the frequency on the T27 as needed.