PPA R37 PPA Select Receiver Instructions For Use and Care MAN154C
Operating Instructions 1. Open battery compartment door on back of receiver by pressing the tab down. 2. If using rechargeable NiMH batteries, slide the Alkaline/ NiMH switch to the NiMH position. Default setting is Alkaline for non-rechargeable batteries. See Figure 1. Figure 1: Battery selection switch Channel Seek ALKALINE/ NiMH SWITCH – AA + + AA – CHANNEL SEEK BUTTON A130 3. Insert 2 AA batteries over the fabric strip. Note correct polarity (+/-). 4.
6. Select Channel. ·· Press Channel Seek button once to search for the desired channel. ·· The LED will blink while searching for an active transmitter channel. ·· If multiple transmitter channels are being used, press the Channel Seek button until you locate the desired channel. ·· Receiver will retain the channel setting when the unit is turned off.
7. Lock Channel: Locate the desired channel, and then turn the power OFF. While holding the Channel Seek button, turn power back ON. See flash codes chart. 8. Unlock Channel: Start with the unit OFF. While holding the Channel Seek button, turn power ON. See flash codes chart. The green LED light is used to indicate: Power, Lock or Unlock Channel status, low batteries, or absence of a transmitter. Refer to flash codes chart below.
Belt Clip Installation For hands-free operation of the PPA R37 receiver, use the provided belt clip to secure the unit on your belt, pocket or pants. To Install: Position the belt clip on the rear of the PPA R37 receiver as shown in Figure 3A. Turn the belt clip 180° left or right as shown in Figure 3B. The belt clip is now installed and ready for use. To Remove: Turn the belt clip 180° so the edge points toward the top of the unit as shown in Figure 3A.
Customer Service If you experience difficulty with your system, call Toll-Free for Customer Assistance: 1-800-843-3544 (U.S.A.) or +1 952 943 2252 (Outside the U.S.A.) If it is necessary to return the system for service, your Customer Service Representative will give you a Return Authorization Number (RA) and shipping instructions. Pack the system carefully and send it to: Williams Sound Attn: Repair Dept. 10300 Valley View Rd.
Lifetime PLUS Limited Warranty Williams Sound products are engineered, designed, and manufactured under carefully controlled conditions to provide you with many years of reliable service. Effective January 1, 2012, Williams Sound warrants the Personal PA® FM Listening transmitters and receivers (models PPA T35, PPA T27, PPA T36, PPA R37, and PPA R35-8) against defects in materials and workmanship under normal use and conditions for the useful lifetime of the product from date of purchase.
Safety Information HEARING SAFETY CAUTION! This product is designed to amplify sounds to a high volume. To protect your hearing and the hearing of others: 1. Make sure the unit is OFF or the volume is turned down before putting on the earphones. 2. Set volume level at the minimum setting you need to hear. 3. Do not allow children or other unauthorized persons to have access to this product.
Recycling Instructions Help Williams Sound protect the environment! Please do not dispose of equipment or used batteries in the household trash. Take the equipment to an electronics recycling center or return to the factory. Take batteries to a retail or community recycling location. Battery Information The PPA R37 uses 2 AA batteries. We commend using Williams Sound Alkaline batteries (BAT 001) or rechargeable batteries (BAT 026) for longer battery life than other brand batteries.
System Specifications PPA Select (PPA R37) Receiver Dimensions: 4.1" H x 2.85" W x 1.38" D (104 mm x 72 mm x 35 mm) Weight: 4.6 oz (130 g) with batteries, 2.6 oz w/o batteries (73g) Battery Type: Two (2) AA non-rechargeable alkaline batteries (BAT 001), approx. 48 hours battery life; or Two (2) AA rechargeable NiMH batteries (BAT 026), 1500 mAh, approx. 30 hours battery life. Operating Freq: 17 channels: 72.1, 72.2, 72.3, 72.4, 72.5, 72.6, 72.7, 72.8, 72.9, 74.7, 75.3, 75.4, 75.5, 75.6, 75.7, 75.
