User manual
24
Personal PA
®
DSP FM Wideband Transmitter
4. ADD-ON MODULE (PPA T45NET only)
The Add-On Module Settings show up in the menu only if the optional ethernet module is installed (PPA T45NET only). This menu
provides the ability to view the Status of the add-on module, choose the IP Address Mode (Static or and Dynamic IP Addressing),
change the IP Address and Subnet Mask, set/change the Security Password and choose whether or not to display the IP Address
on the front display.
4a. Status
The Status screen shows which module is installed (PPA T45NET has the “NETWORK CONTROL 251” board), if a network link
has been established, and the IP Conguration (Static, DHCP Host, or DHCP Client).
To view the Status:
1. Press the Menu button. The display will show “AUDIO SETTINGS” in the selection box.
2. Press the “v” button repeatedly until “ADD-ON-MODULE” is displayed in the selection box.
3. Press the “>” button to access the Add-On Module settings.
4. The selection box will have “STATUS” selected. Press the “>” button to access the “STATUS” screen. The current
information will be shown.
5. When done viewing the status, press the Menu button to exit the menu and return to the main info screen.
4b. Network Settings
The Network Settings screen where the IP Address Mode (Static or DHCP), the IP Address, and Subnet Mask are set.
To change the IP Address Mode (Static or DHCP):
1. Press the Menu button. The display will show “AUDIO SETTINGS” in the selection box.
2. Press the “v” button repeatedly until “ADD-ON-MODULE” is displayed in the selection box.
3. Press the “>” button to access the Add-On Module settings.
4. Press the “v” button repeatedly until “NETWORK SETTINGS” is displayed in the selection box.
5. Press the “>” button to access the Network Settings.
6. The selection box will have “IP ADDRESS MODE” selected. Press the “>” button to highlight the “IP ADDRESS MODE”
screen. The current mode (static or dynamic) will be highlighted in the selection box.
7. Press the “v” or “^” button to change the IP Address Mode.
8. Press the “<” button to exit without saving, or push the “>” button to save. The T45 will reboot if changes were saved.
To change the IP Address:
1. Press the Menu button. The display will show “AUDIO SETTINGS” in the selection box.
2. Press the “v” button repeatedly until “ADD-ON-MODULE” is displayed in the selection box.
3. Press the “>” button to access the Add-On Module settings.
4. Press the “v” button repeatedly until “NETWORK SETTINGS” is displayed in the selection box.
5. Press the “>” button to access the Network Settings.
6. The selection box will have “IP ADDRESS MODE” selected. Press the “v” button to highlight “IP ADDRESS”.
7. Press “>” to access the IP address setting. The current IP Address will be shown.
8. Using the “v” or “^” buttons, change the rst octet (3 digits) of the IP Address.
9. Press the “>” button to access the next octet.
10. Repeat steps 8 and 9 until the last octet has been changed. Use the “<” button to go back and edit previous octets, if
needed.
11. When nished editing the IP Address, press the “>” button once to store the IP Address. The T45 will automatically
reboot. When the T45 is nished booting it will be running on the new static IP Address (the T45 automatically changes to
Static mode if the IP Address is changed and saved).