PPA R38 PPA SelectView™ FM Receiver QUICK SETUP GUIDE
Operating Instructions 1. Open the battery compartment. Slide the battery selection switch to the correct position for the type of batteries that will be used. Use “Alkaline” for non-rechargeable batteries, “NiMH” for rechargeable NiMH batteries (only). (Fig. A) IMPORTANT: If the battery switch is not in the correct position, damage may be caused to the unit. FIG. A: Battery Compartment CAUTION: RECHARGE ONLY NiMH BATTERIES ALKALINE/ NiMH SWITCH 2. Install the AA batteries.
. Turn the unit on: press and hold the power button for three seconds. The power button will illuminate green. (Fig. B) FIG. B: Top of Receiver R38 TOP POWER BUTTON/ LOW BATTERY INDICATOR 3.5mm STEREO/MONO HEADPHONE JACK 4. Select the desired operating channel/frequency on A428 the transmitter. Up to eight transmitters can operate simultaneously on different channels (see 8 channel mode in chart). (Fig. C) 5. Change the receiver to the channel/frequency chosen in step 4.
FIG. C: Channel Selection Chart 17 Ch Mode 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 Letter A B O P I R G H C K N D E J S T F Freq (MHz) 72.1 72.3 72.6 72.8 74.7 75.4 75.7 75.9 72.5 72.2 72.4 72.7 72.9 75.3 75.6 75.8 75.5 8 Ch Mode 1 2 3 4 5 6 7 8 6. To access additional settings, push-and-hold the menu A376 button. The receiver will display “Loading Advanced Setup”. After viewing or changing a setting, push the menu button again to access the next setting.
FIG. D:OLED Menu Buttons DISPLAY LEFT ARROW BUTTON MENU BUTTON RIGHT ARROW BUTTON FIG. E: Main Screen RF SIGNAL STRENGTH SETTINGS LOCKED CHANNEL (OR FREQ.) BATTERY LIFE A309 VOLUME LEVEL 7. Plug in the earphones/headphones into the headphone jack (Fig. B). The earphone/headphone cord is the antenna. 8. Adjust the volume by pushing the left or right arrow A430 buttons (Fig D). 9. To lock (or unlock) all of the settings (except volume), push and hold the left and right arrow buttons.
10. To install the belt clip, position the belt clip on the back of receiver. Turn the belt clip 180˚ left or right to secure the clip. The receiver can now be clipped onto a belt. To remove, turn the belt clip 180˚ so the open end of the clip points up, and gently pull the belt clip off. (FIG. E). FIG. E: Belt Clip Installation 11. After 6 minutes with no RF signal, the receiver will go into a power-saving sleep mode.
Lifetime PLUS Limited Warranty Williams Sound products are engineered, designed, and manufactured under carefully controlled conditions to provide you with many years of reliable service. Williams Sound warrants the PPA R38 against defects in materials and workmanship under normal use and conditions for the useful lifetime of the product from date of purchase. Microphones, earphones, headphones, batteries, chargers, cables, carry cases, and most other accessory products carry a 90-day warranty.
System Specifications FM Receiver, Model R38 Battery Type: Two (2) AA 1.5 V non-rechargeable Alkaline batteries (BAT 001-2), 47 mA nominal current drain, up to 50 hours battery life, or Two (2) AA 1.5 V rechargeable NiMH batteries (BAT 026-2), 47 mA nominal current drain, up to 32 hours battery life per charge, recharges in 14–16 hours, uses CHG 3502 or CHG 3512 Charger Operating Frequencies: Selectable, 17 wideband channels, 72.1 – 75.
System Specifications FM Receiver, Model R38 Display: 1” OLED, for viewing receiver settings Operating Frequencies: 72.1, 72.2, 72.3, 72.4, 72.5, 72.6, 72.7, 72.8, 72.9, 74.7, 75.3, 75.4, 75.5, 75.6, 75.7, 75.8, 75.9 MHz* Compatible Transmitters: PPA T45, PPA T35, PPA T46, PPA T27 Audio Output: 3.
Safety Information Hearing Safety CAUTION! This product is designed to amplify sounds to a high volume. To protect your hearing and the hearing of others: 1. Make sure the unit is OFF or the volume is turned down before putting on the earphones. 2. Set volume level at the minimum setting you need to hear. 3. Do not allow children or other unauthorized persons to have access to this product.
Recycling Instructions Help Williams Sound protect the environment! Please do not dispose of equipment or used batteries in the household trash. Take the equipment to an electronics recycling center or return to the factory. Take batteries to a retail or community recycling location. Battery Information The PPA R38 uses 2 AA batteries. We recommend using Williams Sound Alkaline batteries (BAT 001-2) or NiMH rechargeable batteries (BAT 026-2) for longer battery life than other brand batteries.
Customer Service If you experience difficulty with your system, call Toll-Free for Customer Assistance: 1-800-843-3544 (U.S.A.) or +1 952 943 2252 (Outside the U.S.A.) If it is necessary to return the system for service, your Customer Service Representative will give you a Return Authorization Number (RA) and shipping instructions. This is a quick setup guide. For a detailed user manual, please visit our website.
