Manual and User Guide Personal PA® Tour Guide System Wireless, Portable FM Listening System Transmitter Model PPA T36 Optional Receiver Models PPA R37, PPA R35-8 MAN 158A
PERSONAL PA® FM Tour Guide System, Models TGS PRO 720, TGS PRO MULTI Manual & User Guide Contents Page System Components 3 System Overview 3 Safety Information 4 Recycling Instructions 4 Operating Instructions PPA T36 Transmitter 5-6 PPA R37 Receiver 7 PPA R35-8 Receiver 8 Belt Clip Removal/Installation 9 Battery Information 10 Optional Battery Chargers 11 Hints for Using the System 12 In Case Of Difficulty 13 Warranty 14 System Specifications 2 15-16
System Components Body Pack Transmitter (PPA T36) with (2) AA batteries (BAT 001) Noise-cancelling headband microphone (MIC 100) (10) Receivers (PPA R37 or R35-8) w/batteries (BAT 001) Instruction manual (MAN 145) System carry case (CCS 030 S) System Overview The Personal PA® Tour Guide System is a portable, high-performance, wireless listening system. It is composed of a PPA T36 Transmitter, microphone, and optional PPA R37 or R35-8 receivers equipped with headphones or earphones.
Safety Information Hearing Safety: CAUTION! The tour guide system is designed to amplify sounds to a high volume level which could potentially cause hearing damage if used improperly. To protect your hearing and the hearing of others: 1. Make sure the volume on the receiver is turned down before putting on the earphone or headphone. Then adjust the volume to a comfortable level. 2. Set the volume level on the receiver at the minimum setting that you need to hear. 3.
Using the T36 Transmitter 1. Make sure there are two alkaline or rechargeable AA batteries in the transmitter. If batteries are not installed, see Battery Information on page 11. 2. Plug the microphone cord into the “Mic Jack” on top of the transmitter (FIG. 2). FIG 2: T36 Top View Auxiliary Input Power On/Off/Mute Mic Jack Channel Selector Power On Indicator 3.
Using the T36 Transmitter, cont. Gain Control The gain control can be used to adjust the volume level on both the microphone and auxiliary input. To adjust the volume level, open the battery door and locate the Gain Control (FIG. 4). Use the supplied plastic screwdriver and rotate to increase “+” or decrease “-” the gain. FIG 4: T36 Controls 2:1 1:1 - Gain + - AUX + Comp CH Lock – AA + + AA – j k l m 1. Gain Control 2. Auxiliary Input Level 3. Compression Selector 4.
On/Off Switch Volume Control Wideband FM Receivers OFF Earphone "On" Indicator Receiver Model PPA R37 Jack LED The PPA R37 is a 17-channel receiver operating on the 72-76 MHz bandwidth. Features seek-button channel selection, channel-lock capability, battery-saving Sleep Mode, on/off volume control, power/low battery indicator, and stereo/mono earphone jack. FIG 5: R35 Views On/Off Switch Volume Control OFF Earphone Jack "On" Indicator LED R37 Top R37 Front Operating the Receiver 1.
Receiver Model PPA R35-8 The PPA R35-8 is an eight channel receiver, operating on 72-76 MHz bandwidth. It features a channel selection knob, on/off volume control, LED power and low battery indicator, and an earphone jack (See FIG. 7).
Belt Clip Removal/Installation To Install: Position the belt clip on the rear of the transmitter or receiver unit as shown in FIG. 9A. Turn the belt clip 180º left or right as shown in FIG. 9B. The belt clip is now installed and ready for use. To Remove: Turn the belt clip 180º so the edge points toward the top of the unit as shown in FIG. 9B. Gently pull the belt clip away from the unit to remove. FIG. 9A FIG.
Battery Information Installation/Removal Open the battery compartment by lifting the tab on the back of the transmitter or receiver with your finger. To remove depleted batteries, pull up on the fabric strip. IMPORTANT: If alkaline (non-rechargeable) batteries are being installed, slide the battery selection switch in the battery compartment to the “alkaline” position. See FIG. 10 below. If installing NiMH (or rechargeable) batteries, slide the battery selection switch to the “NiMH” position.
Optional Battery Chargers Fig: 11A: CHG 3512 / 3512 PRO Multi-Charger TFP 037 DC Power Connection Fig: 11B: CHG 3502 Dual-Bay Charger CHG 3502 Rear View Receiver or Transmitter Charging LED Indicator TFP 041 DC Power Connection For more information on available chargers, visit www.williamssound.com or call +1 952 943 2252.
Tips for Using the System The nominal operating distance between the transmitter and receiver is about 46 meters (150 feet). The operating range will vary in different buildings and surroundings. In some locations, the signal may momentarily disappear. This is called a “drop-out” and is due to reflection and cancellation of the radio signal. Moving a few feet should restore the signal. Keep the transmitter and receiver units at least 1 meter (3 feet) apart.
In Case Of Difficulty If your Tour Guide System is not working, check the following: 1. Read through the manual and user guide carefully to verify proper setup and installation of your system. 2. Make sure the batteries are fresh or completely charged and that the “plus” and “minus” terminals are installed correctly. 3. If the rechargeable batteries work for a short period of time (less than 1 hour) even after they are fully charged, they must be regenerated.
Limited Warranty Williams Sound products are engineered, designed, and manufactured under carefully controlled conditions to provide you with many years of reliable service. Williams Sound warrants the Personal PA® Tour Guide System against defects in materials and workmanship for five (5) years. During the first five years from the purchase date, we will promptly repair or replace the Personal PA® Tour Guide System.
System Specifications Transmitter, Model PPA T36 Dimensions: Weight: Color: Battery Type: Operating Freq’s: Stability: Modulation: RF Output: Freq Response: Signal-to-Noise Ratio: Transmit Antenna: Microphone: External Controls: Mic Input: Aux Input: Audio Compression: Compatible Receivers: Approvals/Directives: Warranty: Note: Receiver, Model PPA R37 Dimensions: Weight: Color: Battery Type: Current Consumption: Operating Freq.
Receiver, Model PPA R35-8 Dimensions: Weight: Color: Battery Type: Current Consumption: Operating Freq: Intermediate Freq: FM Deviation: De-emphasis: LED Indicator: Sensitivity: Input Overload: Frequency Response: Signal to Noise ratio: Receive Antenna: Audio Output: Output Connector: Squelch: Notes: Approvals: Warranty: 4.5” H x 2.8 W x 1.1” T (115 mm x 71 mm x 28 mm) 4.