User's Guide

Sound through receivers is loud, but distorted. Noise (room

noise or electronic noise) seems to grow after talking stops.

“Limiting” appears on LCD display.

•

Turn the “Gain Control” on the back of the T800 counterclock-

wise to decrease the audio level.

Sound through the receivers is weak and noisy.

•

Turn the “Gain Control” on the back of the T800 clockwise to

increase the input signal strength. .

•

Increase the input signal level from the sound system.

Buzzing or humming noise in sound system.

•

There is nothing wrong with the T800 transmitter. One or more

pieces of equipment in the sound system are being disturbed by

RF (Radio Frequency) signals produced by the T800. The most

likely suspects are your amplier, mixer, or tape deck. The RF

gets into the other equipment primarily through the power cord,

speaker wires, or unshielded inputs, all of which can act as

antennas. Try the following steps:

•

Move the transmitter away from the other sound equipment.

•

Make sensitive equipment more immune to RFI/EMI. The

manufacturers of your audio equipment may offer application

notes for this purpose. Williams Sound offers a document giv-

ing suggestions for improving RF immunity in existing audio

equipment. (Technical Bulletin: Buzz Or Hum In The Sound

System, FRM 531) Unless you have the necessary technical

skills, this is best left to a qualied electronics repair technician.