User guide

Williams Sound

Helping People Hear

Power

Input

ST = Stereo operation

L = 95 kHz operation

R = 250 kHz operation

RCA Jack (connect from TV speaker output).

STEREO operation:

Use both RIGHT and LEFT jack.

95 kHz operation:

Use LEFT jack only.

250 kHz operation

: Use LEFT jack only.

Mic

Jack

DC12V

L MIC

ST L R

TV Microphone

If an RCA connection is unavail-

able, use the provided TV micro-

phone to pickup the sound source

directly from the TV loud speak-

er as shown on right.

TX295

TX295 Transmitter (Rear View)

STEP 1: CONNECT THE TRANSMITTER POWER SUPPLY

Plug the Power Supply cord into the “DC 12V” jack 1 on the back

of the TX295. Then plug the Power Supply into an AC outlet. When

the receiver is placed into the charging cradle built into the top of the

transmitter, the center charging indicator on the front of the TX295

will turn on. When the spare battery is plugged into the left or right

battery charging port on the transmitter, the corresponding charge

indicator light will turn on.

TEP 2: CONNECT THE TRANSMITTER TO THE AUDIO SOURCE

Use the Audio Cable supplied to connect the TX295 Transmitter

directly to the TV, VCR, or other equipment output jacks:

STEREO OPERATION: (RECOMMENDED FOR HIGHEST

AUDIO QUALITY): 1) Connect the RCA plugs from the TV or

VCR speaker output into the LEFT and RIGHT RCA jacks on the

TX295 transmitter

3. Next, slide the stereo/mono switch 2 on

the TX295 transmitter into the “ST” position. Your transmitter is

now set for stereo operation. Lastly, you will need to adjust the

RX295 receiver for stereo transmission (see instructions on page 9).