Specifications

Ideally, the TX295 Transmitter should be at ear-level height or above. The infrared light pat-
tern is much like a floodlight “cone” as it leaves the transmitter, with the best reception inside
the cone.
Sunlight can cause infrared interference in the form of a buzz, hiss, or static. Thus, the system
cannot be used outdoors and may not work properly inside if a lot of direct sunlight is present.
Closing drapes or blinds will help if sunlight is a problem.
Any number of receivers may be used with the TX295 Transmitter, but use only one transmit-
ter in a room at the same time. Otherwise, interference will occur.
S TEP 2: C ONNECT THE T RANSMITTER P OWER S UPPLY
Plug the Power Supply cord into the “DC 12V” jack on the back of the TX295. Then plug the
Power Supply into an AC outlet.
S TEP 3:
S
ELECT AN O PERATING F REQUNCY FOR THE TX295 T RANSMITTER
To use the TX295 transmitter with the RX4 receiver, you must first setup the transmitter to oper-
ate in 95 kHz mode. Referring to the diagram above, slide the Stereo/Mono Selection Switch to
the “L” Left position for 95 kHz. The transmitter is now setup to operate with the RX4 receiver.
S TEP 4: C ONNECT THE T RANSMITTER TO THE A UDIO S OURCE
If you are using the
TV
Microphone, plug it into the “Mic” jack on the TX295 as shown. Use
the
V
elcro strip supplied to attach the microphone near the loudspeaker of your TV. The micro-
phone will allow you to play the TV at lower volume for other listeners and will pick up other
important sounds like the telephone or doorbell ringing.
T
o use the supplied
Audio Cable to connect the TX295 T
ransmitter dir
ectly to TV
, VCR, or
other equipment output jacks:
Connect the LEFT RCA plug from the TV (or VCR) speaker output into the LEFT RCA
jack on the TX295 transmitter. Remember, the Stereo/Mono Selection Switch must be in
the “L” Left position to transmit in 95 kHz!
When the
Audio Inputs are used, the Mic input is automatically disabled.
NOTE:
The
TX295 has an automatic shut-of
f feature that turns the
T
ransmitter of
f 90 seconds
after the audio signal is no longer present.
Williams Sound
®
Helping People Hear

2
S ETTING UP THE TX295 T RANSMITTER
Power
I
nput
ST = Stereo mode
L
= 95 kHz mode
R = 250 kHz mode
S
tereo/Mono Switch
RCA Jack (connect from TV speaker output).
STEREO: Use both RIGHT and LEFT jack.
9
5 kHz or 250 kHz: Use LEFT jack only.
M
ic
Jack
R
+
-
D
C12V
L MIC
ST L R