Installation guide

Williams Sound

Helping People Hear

INSTALLATION STEP 3: AUDIO SOURCE CONNECTION

The WIR TX10 accepts audio signals from balanced or unbalanced line level outputs,

transmitting audio with excellent fidelity. Therefore, be sure to connect its input to the

highest quality audio source your system can offer.

Step 1: Determine the length of cable needed to reach from the audio source to the TX10

Transmitter. You will need to cut it to length. Make sure you leave some slack at

each end.

Step 2: Prepare the cable for an unbalanced or balanced connection. (See Figure 8a.)

Step 3: Connect the audio cable to the Audio Input terminals using Figure 8b as a guide.

In Phase

Balanced Line Using 1/4' Connector

Unbalanced Line Using 1/4" Connector

In Phase

3 Pin Connector

Balanced Line Using 3–Pin Connector

3 Pin Connector

Unbalanced Line Using 3–Pin Connector

GND

NEG

POS

GND

NEG

POS

Balanced

–

Signal

Shield

Unbalanced

–

Signal

Shield

Jumper

To TX10

FIGURE 8A: CONNECTING THE TX10 TO AN AUDIO SOURCE

FIGURE 8B: CONNECTING AN AUDIO SOURCE TO THE TX10