Full Product Manual

Installation

Thermostat Mounting

1. To remove the thermostat cover, grasp cover and squeeze

both sides firmly, then lift to remove cover. Carefully

remove and discard the packing tab protecting the switch

contacts.

2. Connect thermostat wires to the terminal screws on the

front of thermostat base.

3. Push any excess wire back through hole in the wall and

plug the hole with insulation to prevent drafts from affecting

thermostat operation.

4. Being sure to level thermostat for the best appearance.

Fasten the thermostat base to the wall through the

mounting holes with the screws provided.

5. Replace the thermostat cover.

Note: Refer to the installation instructions packed in the

thermostat carton if you have any doubt about the above

procedures.

FIGURE 9

SQUEEZE FIRMLY BOTH

SIDES AND LIFT TO

REMOVE COVER