Instruction manual

ManualsBrandsWilliams ManualsHeating, Ventilation, and Air Conditioning35,000 BTU/Hr Enclosed Front Console Room Heater Natural Gas with Blower

MODEL NOS:

FOR NAT. GAS ONLY

2001612; 2001622

3501512; 3501522

3501912; 3501922

5001512; 5001522

5001912; 5001922

6501512; 6501522

6501912; 6501922

MODEL NOS.

FOR L.R GAS ONLY

2001611 2001621

3501511 3501521

3501911 3501921

5001511; 5001521

5001911; 5001921

6501511; 6501521

6501911; 6501921

INSTALLATION & OPERATING INSTRUCTION MANUAL

350 MODEL SERIES SHOWN

READ THIS OWNERS MANUAL

CAREFULLY BEFORE YOU INSTALL

YOUR NEW WILLIAMS

VENTED ROOM HEATER

WARNING: Improper installation, adjust-

ment, alteration, service or maintenance

can cause injury or property damage.

Refer to this manual. For assistance or

additional information consult a qualified

Installer, service agency or the gas

supplier.

WARNING: Do not install any of these fur-

naces (Natural or L.P. Gas) in mobile

homes, trailers, or recreational vehicles.

WARNING: If the information in this l

manual is not followedexactly, a fireor ex-

plosion may result causing property

damage, personal injury or loss of life.

-- Do notstore or use gasolineor other flam-

mable vapors and liquids in the vicinity

of this or any other appliance.

-- WHAT TO DO IF YOU SMELL GAS

• Open all windows.

• Do not try to light any appliance.

• Do not touch any electrical switch; do

not use any phone in your building.

• Extinguish any open flame.

• Immediatelycallyourgas supplierfrom

a neighbor's phone. Follow the gas

supplier's instruction.

• If you cannot reach your gas supplier,

call the fire department.

-- Installation and service must be per-

formed by a qualified installer, service

agency or the gas supplier.

WILLIAMS Furnace Co., 225 Acacia St., Colton, CA 92324

PRINTED IN USA 4/98 P500407

Summary of content (23 pages)

PAGE 1
INSTALLATION & OPERATING INSTRUCTION MANUAL MODEL NOS: FOR NAT. GAS ONLY 2001612; 2001622 3501512; 3501522 3501912; 3501922 5001512; 5001522 5001912; 5001922 6501512; 6501522 6501912; 6501922 350 MODEL SERIES SHOWN MODEL NOS. FOR L.
PAGE 2
IMPORTANT TO THE PURCHASER: Keep this warranty and the installation and homeowner's LIMITED instructions for your future reference. WARRANTY The Manufacturer, Williams Furnace Co., warrants this wall furnace or heater to the original purcheser under the following conditions: LIMITED ONE-YEAR WARRANTY 1.
PAGE 3
A Word From The Manufacturer Dear Customer, To set up our furnace assembly procedures, several hundred quality assurance, safety audit and design performance tests have been conducted according to the standards provided by the American National Standards Institute, the Department of Energy and our certification agency -- the American Gas Association Laboratories. This was done to assure you of receiving the best value and most reliable appliance of its type available today.
PAGE 4
Safety Rules WARNING. umn. The maximum inlet gas supply pressure is 13" water column. READ THESE RULES AND THE INSTRUCTIONS CAREFULLY. FAILURE TO FOLLOW THESE RULES AND INSTRUCTIONS COULD CAUSE A MALFUNCTION OF THE FURNACE. THIS COULD RESULT IN DEATH, SERIOUS BODILY INJURY, AND/OR PROPERTY DAMAGE. 7. ANY SAFETY SCREEN, GUARD OR PARTS REMOVED FOR SERVICING FROM THIS APPLIANCE MUST BE REPLACED PRIOR TO OPERATING THE APPLIANCE TO AVOID PROPERTY DAMAGE, BODILY INJURY OR DEATH. 8.
PAGE 5
LOCATING THE HEATER -- MINIMUM FRESH AIR OPENING IS 1 SQUARE INCH PER 1,000 BTUIHR. WARNING: Gas burning appliances require air for combusion and proper venting. Minimum fresh air opening of 1 square inch per 1000 BTU per hour input rating must be provided for ventilation. EXAMPLE: A 30,000 BTU per hour input unit requires the equivalent of a 30 inch wide window be open 1 inch for safe operation. In 1. 2. 3. 4. 5. A.
PAGE 6
PIPING THE GAS TO THE HEATER State and local authorities have established codes regulating the installation of gas burning equipment. Consult your gas supplier or gas company for complete information. In the absence of local codes, all aspects of the installation must comply with the national fuel gas coda ANSI Z223.1. In Canada: Follow CAN/CGA-B149.1(2) Canadian Standard. A. Use 1/2-inch pipe or semi-rigid tubing for natural and liquefied petroleum gases. DO NOT USE FLEXIBLE HOSE.
PAGE 7
WARNING .WARNING DANGER OF ILLNESS BODILY INJURY OR DEATH THE FURNACE AND ANY OTHER FUEL BURNING APPLIANCE MUST BE PROVIDED WITH ENOUGH FRESH AIR FOR PROPER COMBUSTION AND VENTILATION OF FLUE GASES. MOST HOMES WILL REQUIRE THAT OUTSIDE AIR BE SUPPLIED INTO THE FURNACE AREA.
PAGE 8
Thermostat Installation MOUNTING Models with the last two digits "11" (or) "12" utilize a builtin thermostat control system operated by a heat sensing bulb located in the burner compartment. 1. To remove thermostat cover, squeeze both sides and lift. IMPORTANT I 2. Connect thermostat wires to the thermal screws on the back of thermostat base. ting tubing. andle the bulb with care. Do not kink the connec, Models with the last two digits "21" (or) "22" are operated by a millivolt type thermostat.
PAGE 9
Start-Up Procedure WARNING CHECK THE GAS INPUT (NATURAL GAS ONLY) DANGER OF PROPERTY DAMAGE, BODILY INJURY OR DEATH. LIQUEFIED PETROLEUM L.P. GAS IS HEAVIER THAN AIR AND IT WILL SEI-rLE IN ANY LOW AREA, INCLUDING OPEN DEPRESSIONS AND IT WILL REMAIN THERE UNLESS AREA IS VENTILATED. WARNING NATURAL GAB HEATING VALUE (BTU PER CUBIC FOOT) CAN VARY SIGNIFICANTLY, THEREFORE, IT IS THE INSTALLER'S RESPONSIBILITY TO BEE THAT BTU INPUT TO THE FURNACE IS ADJUSTED PROPERLY.
PAGE 10
FOR YOUR SAFETY, WILLIAMS GAS CONTROL READ BEFORE LIGHTING VALVE P322051 (OR) P322052 (OR) P500419 (OR) P5004_,0 I r WARNING: If youcausing do not property follow these instructions a fire may result damage, personal exactly, injury or lossorofexplosion life, A. This appliance has a pilot which must be lighted by hand. When lighting the pilot, follow these instructions exactly. • B. BEFORE LIGHTING smell around the appliance ares for gas.
PAGE 11
I m ..u,tc.us,., or,o.o,,i. A. This appliance has a pilot which must be lighted by hand. When lighting the pilot, follow these instructions exactly. B. BEFORE LIGHTING smell around the appliance area for gas. Be sure to smell next to the floor because some gas Is heavier than sir and will settle on the floor. • WHAT TO DO IF YOU SMELL GAS • Do not try to light any appllancs. • Do not touch any eieotdc swifch; do not use any phone In your building.
PAGE 12
FOR YOUR SAFETY, WILLIAMS READ BEFORE GAS CONTROL LIGHTING VALVE P172100A & P172200A WARNING: If youcausing do not property follow these instructions a fire may result damage, personal exactly, injury or lossorofexplosion life. A. This appliance has a pilot which must be lighted by hand. When lighting the pilot, follow these Instructions exactly. B. BEFORE LIGHTING smell around the appliance area for gas.
PAGE 13
WARNING: If you do not follow these instructions exactly, a fire or explosion I I may result causing property damage, personal injury or loss of life. A. This appliance has a pilot which must be Ughted by hand. When lighting the pilot, follow these Instructions exactly. B. BEFORE LIGHTING smell around the appliance area for gas. Be sure to smell next to the floor because some gas Is heavier than air end will settle on the floor. • If you cannot department.
PAGE 14
How To Care For Your Heater CABINET FINISH Clean cabinet with damp rag. Never use abrasive cleaners. Cabinets are finished with heat resistant baked enamel -- DO NOT refinish with wall paint. REMOVABLE CABINET TOP (350, 500, & 650 MODEL SERIES ONLY) For ease of cleaning, access or replacement of internal parts, the top of this heater can be removed by following these steps: Refer to Fig. 6. 1. Remove (3) Brackets on roar of heater securing Cabinet Top to Back Plate. 2. Pull Cabinet Top forward and lift up.
PAGE 15
INSTALLATION & 2101 (AVAILABLE ONLY OPERATING BLOWER FOR INSTRUCTION ACCESSORY 350, 500, & 650 NOTE:All electrical work must be conform to your local codes and ordinances or in their absence, with National Electrical Code,ANSI/NFPA 70. If you are not famnlar with wtdng codes In general, havea competentdectrlclando this job. in CANADA CANADIANELECTRICALCODE C22.1. MODEL SERIES) WARNING OR DEATH.
PAGE 16
INSTALLATION (con't) & OPERATING 21 01 INSTRUCTION BLOWER ACCESSORY STEP 4. Remove temperature dial from control valve (B) and discard. Install the coupling (N) to control valve and secure it by tightening set screw. Slide previously assembled control rod down through control box and insert it into coupling attached to the control valve. Secure rod to couplincj with cotter pin. STEP 5. Secure cable provided. STEP 6. (Refer to clamp RG.
PAGE 17
INSTALLATION & 2101 - OPERATING BLOWER INSTRUCTION ACCESSORY - REPLACEMENT PARTS (350, 500, &: 650 MODEL SERIES ONLY) 13 17 0 2 3 NO._._ ITEMS 5,6,7, & 16 ARE NOT SUPPUED OR REQUIRED Y,IIH WAll TYPE THERMOSTAT MODELS (USE ITEM NO. PART REPLACEMENT PARTS LIST MANUFACTURES ONLY NO. P500250 ASSEMBLY, 2 K7003-6087 PLATE, 3 P500137 BLOWER 4 K5150-6029 5 SEE P_ _ 18 ASSY, MOTOR MOTOR MTG. WHEEL BLOWER CONTROL PARTS) ITEM PART NO. NO.
PAGE 18
WILLIAMS GAS FIRED ROOM HEATER REPLACEMENT PARTS FOR 20016 MODEL SERIES I • I .
PAGE 19
REPLACEMENT PARTS FOR MODELS 2001611 2001612 2001621 2001622 !KE'_ NO. DESCRIPTION 2001611 2001612 2001621 2001622 1 WRAPPER ASSEMBLY K000275 K000275 K000275 K000275 2 DRAFT DIVERTER ASSY.
PAGE 20
WILLIAMS GAS FIRED REPLACEMENT 350, FOR PARTS LISTING SEE PAGE 21 (OR) 22 USE ONLY MANUFACTURERS AUTHORIZED PARTS 500, & (ENCLOSED 650 ROOM HEATER PARTS MODEL SERIES CONSOLES) ./_-.,.
PAGE 21
ENCLOSED CONSOLES REPLACEMENT PARTS FOR BUILT-IN THERMOSTAT MODELS 3501512 3501912
PAGE 22
ENCLOSED CONSOLES REPLACEMENT PARTS FOR WALL THERMOSTAT MODELS 3501522 3501922 KE_ NO. 1 3501521 3501921 DESCRIP'IION PANEL SIDE (R.H.) 2 ' THERMOSTAT 5001522 5001922 5001521 5001921 6501522 6501922 6501521 6501921 3501522 3501922 3501521 3501921 5001522 5001922 5001521 5001921 6501522 6501922 6501521 6501921 K000204 K000204 K000205 K000205 K000206 K000206 P322016 P322016 P322016 P322016 P322016 P322016 3 INLET DUCT K"/000-.6022 K7000.-6022 K7000-6022 K7000.
PAGE 23
Service Hints If your heater fails to work right, you may avoid inconvenience and the cost of a service call by checking the following points before you call for service. FOR YOUR SAFETY owners manual MODEL NOS. FOR NAT. GAS ONLY 2001612; 3501512; 3501912; 5001512; 5001912; 6501512; 6501912; 2001622 3501522 3501922 5001522 5001922 6501522 6501922 Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance. POSSIBLE CAUSE If you smell gas: 1.