Installation & Assembly

ManualsBrandsWilliston Forge ManualsCeiling LightsMurrow 3-Light Kitchen Island Linear Pendant

 Page:  ‐1‐/4

1. Wesuggestinstallationbyalicensedelectrician.

2. Pleasereadtheinstructioncarefullyandsaveitasyoumayneeditatlatertime.

3. Beforeyoustart,NEVERattemptanyworkwithoutshuttingofftheelectricityuntiltheworkisdone.A).Gotothemain

fuse,orcircuitbreaker,boxinyourhome.Placethemainpowerswitchinthe“OFF”position.B).Placethewallswitch

inthe“OFF”position.

4. Mountingsurfaceshouldbeclean,dry,flat,strongenoughand1/4”largerthanthecanopyonallside.Anygapsbetween

themountingsurfaceandcanopyexceeding3/16”shouldbecorrectedasrequired.

5. Makesurethattheceilingorwallcanstandtheweightofthelampbeforefixture.

6. Makesurethevoltageyouareusingis120V.Themaximumwattageis60Wperbulb.

7. Keepthelampawayfromacidicandbasicobjectsincaseofdamagingthesurfaceofthelamp.

8. Whenreplacingbulb,youshouldturnofforunplugthelampandyoumustwaituntilitiscoolasbulbsgethotquickly.

9. Thesafetyinstructionsappearinginthismanualarenotmeanttocoverallpossibleconditionsthatmayoccur.Itmust

beunderstoodthatcommonsense,cautionandcaremustbeusedwithanyelectricalproducts.



IMAGEFORFINISHEDPRODUCT：



WARNING(Toreducetheriskoffire,electricshock,orinjurytopersons):

Summary of content (4 pages)

PAGE 1
WARNING (To reduce the risk of fire, electric shock, or injury to persons): 1. We suggest installation by a licensed electrician. 2. Please read the instruction carefully and save it as you may need it at later time. 3. Before you start, NEVER attempt any work without shutting off the electricity until the work is done. A). Go to the main fuse, or circuit breaker, box in your home. Place the main power switch in the “OFF” position. B). Place the wall switch in the “OFF” position. 4.
PAGE 2
TOOLS REQUIRED (NOT INCLUDED): Before doing assembly and installation please prepare the needed tools as below picture PARTS TYPE & QTY INCLUDING: (B) Round mounting plate (1) (C) Green ground screw (1) (E) Canopy (1) (F) Loop (2) (G) Quick link (2) (H) Knob ball (2) ( I ) Tube (6) (J) Glass (8) (K) Stud (1) (L) Fixture (1) ACCESSORIES & QTY ENCLOSED: (A)Plastic wire connector (3) (D) Mounting screw (2) ASSEMBLY & INSTALLATION INSTRUCTIONS: 1.
PAGE 3
4. According your desired hanging length to select and use the tubes (I) then pass the wires through the tubes(I) to the top of loop .Gently pull wires and thread the tubes onto the fixture (L) till tight 5. Unscrew the knobs from canopy then remove the mounting plate (B) Attach a quick link (G)to loops(F) to connect the cannopy (E) and (I) Gently and carefully pass the wires through the loop(F) to the top of cannopy (E) 6. Attach the mounting plate to outlet box with the mounting screws 7.
PAGE 4
Twist plastic wire connector(A) until wires are tightly joined together,then carefully stuff all wires into the outlet box 8.Raise canopy (E) to ceiling and secure canopy (E) in place by tightening knobs (H) onto the threaded nipple on mounting plate 9. Check everything are already installed properly, then you could turn on the light. CLEANING To clean, wipe fixture with a soft cloth. Clean glass with a mild soap.