Installation & Assembly

All Light fixtures are manufactured to be installed to a standard round junction box. The
instructions are written to start with a pre-existing junction box that is controlled by a switch. All
light fixtures are dimmer switch compatible. For the best results be sure that the light bulbs used
are also dimmer switch compatible.
1. Remove all items from their packaging.
• Light Fixture (actual light fixture will vary – but all fixtures that have a center finial follow
these instructions)
• Mounting hardware – both items are attached to the back of the fixture
- Crossbar
- Wire nuts
2. Remove the wire tie holding the hardware to the wires
3. Adjust the pendant to the desired length by adjusting the plastic clip above the crossbar
4. Connect the wires and connect to main power using the wire nuts. Shorten the wires as needed.
5. Remove the Crossbar from the finial and mount to the junction box
6. Push any excess wire into the crossbar so that the base of the socket can touch the crossbar
without any wire interfering
7. Hold the fixture to the crossbar, aligning the finial
8. Attach the finial to the crossbar by turning to the right
9. Align the fixture in the direction desired
10. Remove the screws from the cage and fit around Black Porcelain Socket. Tighten the cages using
screws.
11. Reconnect the power to the circuit (breaker or fuse)
12. Install your light bulbs and enjoy!