Installation & Assembly_Queen

Customer Service 908-368-1025︱ Page 1 of 3

MOD-5436/5437 FULL/QUEEN BED

Thank you for purchasing the FULL/QUEEN BED！

Before you start, here is some helpful advice:

1.We suggest you spend a short time reading through this leaflet and then follow the simple step by step

instructions.

2.Owing to the size and weight of the bed, we recommend that it is assembled by two adults, on a carpeted or

padded area, in the room that it is intended for. Approx assembly time: 45 minutes.

3.Please do not use any tools other than those provided or recommended in these instructions.

4.Please do not throw away any of the packaging or the instruction until you have checked all the components and

hardware and the furniture is fully assembled. Please ensure that the packaging is disposed of in a safe

environmentally friendly way.

5.Assemble all components loosely until advised to tighten. Depending on use, it may be necessary to tighten the

components from time to time, so please save the tools that has been provided.

6.Please keep all fitting out of reach of children.

Hardware:

Component:

Short Bolt M6x20mm x28

Flat Washer x4

Rubber Insert x16

Allen Wrench x1

Headboard x1

Footboard x1

Side Rail x2

Double Slat x4

Single Slat x8

Low Post x2

Center Rail x1

Support Leg x4

Medium Bolt M6x35mm x4

Long Bolt M6x50mm x4

Open Wrench x1

Nut M6 x8

PAGE 1
MOD-5436/5437 FULL/QUEEN BED Thank you for purchasing the FULL/QUEEN BED！ Before you start, here is some helpful advice: 1.We suggest you spend a short time reading through this leaflet and then follow the simple step by step instructions. 2.Owing to the size and weight of the bed, we recommend that it is assembled by two adults, on a carpeted or padded area, in the room that it is intended for. Approx assembly time: 45 minutes. 3.
PAGE 2
MOD-5436/5437 FULL/QUEEN BED STEP 1: Insert Low Post (6) into Headboard (1) as shown. Attach by using Flat Washer (E) and Short Bolt (A) from the holes on the back of Low Post (6) and Headboard (1). Use Allen Wrench (G) to tighten Short Bolts (A) clockwise until secure. E A 1 1 A G A E 6 Ba ck wit h ho l es A 6 Ax4 6 Ex4 Gx1 Hardware & Tool required STEP 2: Take out all Double Slats (4), Single Slats(5) and Side Rails(3) and place them as shown.
PAGE 3
MOD-5436/5437 FULL/QUEEN BED STEP 3: Place Center Rail (7) and 1 piece of Support Legs (8) under assembled Double Slat (4) and Single Slat (5) as shown. Insert 4 pieces of Long Bolt (C) into the 4 holes right on Center Rail (7) to connect it with Support Legs (8) as shown. Insert 4 pieces of Medium Bolt (B) into 4 other holes left on the Center Rail(7) to connect it with Support Legs (8) as shown. Secure the above 8 pieces of Bolt (B&C) with Nuts (D) from the bottom of Support Legs (8) at same time.