Assembly Instructions

Important: Always disconnect the power before installing or replacing bulbs and before cleaning or other maintenance.
This light should be installed by a licensed electrician
CARE INSTRUCTIONS
Dusting – Use a clean, dry cloth.
Cleaning – To protect the finish,
avoid any harsh abrasives or chemicals.
outlet box
back plate
mounting plate
outlet box screw
cap nut
glass holder
medium base bulb
silicone washer
thumb screw
glass
anchor
wood screw
Assembly Instructions
2-Light Bath Bar, 3-Light Bath Bar, 4-Light Bath Bar
LAMP INSTALLATION AND ASSEMBLY
1. Shut off power to the outlet box. (fig. A)
2. Attach the mounting plate to the outlet box, secure with outlet box screws.
Use additional anchors and wood screws for mounting (included).3. Make
appropriate electrical connections using wire nuts:
a. Connect the fixture’s live wire (black) to the live outlet box wire.
b. Connect the fixture’s neutral wire (white) to the neutral outlet box wire.
c. Connect fixture’s ground wire (green or uncoated) to the ground outlet
box wire. If no ground is present in outlet box, connect fixture’s ground
wire to the mounting plate using the green screw (included).
d. Carefully place connections in outlet box.
4. Attach back plate to mounting plate, tighten with cap nuts.
5. Install 60W medium base bulbs (not included).
6. Attach glass to glass holders, tighten with silicone washers and thumb screws.
7. Restore power to the fixture.