Installation Guide

1
BATHROOM VANITY INSTALLATION GUIDE
GETTING STARTED
TOOLS AND MATERIALS:
Ensure that you have gathered all the required
materials that are needed for the installation.
Ensure that your bathroom door is adequately
supported, and the finished door is level.
Ensure that there is adequate support behind the
bathroom wall before installation.
Tape Measure*Marker*
Drill*
Screwdriver*
Stud Finder
Level
Neutral Cure
Silicone Sealant
Damp Cloth
Wood Shims
NEVER LIFT THE VANITY TOP FLAT NEVER CARRY THE VANITY TOP FLAT
2
Step 1: Cabinet Installation
1. Determine the location where you would like to install
your vanity.
2. Locate and mark the location of the studs to which
you will fasten your vanity. You can locate studs by using
a stud finder.
Important: If the studs in your bathroom do not line up
to the mounting location for your vanity, wood blocking
can be installed between the studs using standard 2 x
4’s. If wood blocking needs to be installed behind the
nished wall, we recommend consulting a professional
if you are unfamiliar with this type of installation.
3. Place the vanity in the installation location. Verify that
the vanity cabinet is level. If the vanity is not level, adjust
the feet (if applicable) or use wooden shims to adjust as
necessary.
4. Attach the vanity to the wall by screwing through
the back of the vanity cabinet. Use the marked stud
locations as a guideline. Proceed to Step 2 for attach-
ing your counter top.
SCREWS SCREWS
WALL STUDS
MOUNTING RAIL
BATHROOM VANITY INSTALLATION GUIDE