Owner's manual

The Mezzo mounts on top of the Hourglass stand, but does not bolt to it. The setscrews
sit inside the holes in the top of the stand.
Section 4.6—Set Up #3 Mezzo Convergent Synergy on Custom Stand or
Shelf
The speaker should be rotated so that the midrange drivers are firing just below the
listening position. Once you have made and mounted the custom bracket, setup the Mezzo
Convergent Synergy as follows:
1. Lay the Mezzo Convergent Synergy onto its side.
2. Using the provided 3/16 Allen wrench, back out the 4 setscrews from the
bottom of the Mezzo Convergent Synergy to the desired length.
Note: Be sure that the Allen key end of the setscrew is facing out.
reSiStor acceSS
Main in binding poStS
figure 12 – Mezzo conVergent sYnergY cable connection and resistor access
WooFer reSiStor acceSS
M e z z o C o n v e r g e n t S y n e r g y o w n e r ’ S M a n u a l
48
Wilson Audio Specialties
.