Instruction Manual

Note: Before setting up the WATCH Center Series 3, study carefully Section 3, “In Your
Room.” It provides valuable information on determining the ideal room location for your
speakers.
Section 4.1—Final Setup
Preparation
You will need the following items:
• Supplied hardware kit
• Tape measure
• Known listening position
Your dealer is trained in the art and science of the Wilson Audio Setup Procedure
(WASP) outlined in Section 3, and Wilson Audio recommends dealer installation of your
new loudspeaker.
Section 4.2—Center Channel Spikes
The Center channel comes with 2 sets of spikes with a nut, a diode and spacers, and
two sets of spikes with only the spike and nut. This will allow the speaker to be tilted to a
variety of angles. These spikes also provide acoustical isolation as well as optimal height
placement for your speakers. There are three ways of assembling the spikes (without di-
odes, without spacers, or with one or two spacers), and your choice will depend on the
location of the Center channel and personal tastes. While the Center Series 3 baffle is de-
signed to angle upward toward the listener, the spacers are provided to allow for additional
rotation of the Center, such as for installations where the listening position is close to the
loudspeakers. If the speaker is floor mounted, additional upward tilt may be desirable so
the drivers are firing towards the listener. If the speaker is mounted above the listening ear
S E C T I O N 4 . 1 — F I N A L S E T U PW A T C H C E N T E R C H A N N E L S E R I E S 3 O W N E R ’ S M A N U A L
40 41
Wilson Audio Specialties
Wilson Audio Specialties