Instruction Manual

Center Channel Configurations
The WATCH Center Channel has been designed to accommodate most any mounting
location. These locations, in order of preferred location, are as follows:
#1 Center Channel on Stand (Recommended Location)
#2 Center Channel on Floor
#3 Center Channel on Custom Stand or Shelf
#4 Center Channel on Ceiling
The Center Channel crossover has been optimized for use with the Center stand. This
is the preferred location. When you mount the Center channel in most other locations you
will begin to see more boundary interactions, which may alter the performance of your
the speaker. Nevertheless, the Center channel will certainly out-perform any other Center
channel placed in a given location.
Placing the WATCH Center Series 3 in any location other than on the Wilson Audio
WATCH Center stand will require the Center channel to be rotated towards the listening
MEASURE EAR HEIGHT
MEASURE LISTENING DISTANCE
FI GU RE 9 – MEA SU RED LISTEN ING DISTANCE AND EA R HEI GHT
position. This will allow the Center channel to take advantage of the propagation delay
correction technology (PDC). Simply placing the Center in a location without following the
directions below will hinder the performance of the Center channel. With the correct PDC
you will find the vocals and dialogue more realistic and satisfying. As with any component
in your system that offers increased resolution and detail, a careful setup is required.
There are four different setup procedures depending on your Center channel location.
The possible Center channel configurations are as follows:
Section 4.4—Setup #1 Center Channel on Floor
Section 4.5—Setup #2 Center Channel on Stand
Section 4.6—Setup #3 Center Channel on Custom Stand or Shelf
Section 4.7—Setup #4 Center Channel on Ceiling
Please proceed to the indicated section for your particular installation for detailed
setup instructions.
Section 4.4—Setup #1 Center Channel on Floor
The floor mounted Center channel must be rotated up toward the listening position.
This is done by using a taller spike in the front than in the back of the speaker (see Figure 9).
The default rotation is set by using a combination of a spike, nut, and a diode. If required,
additional rotation can be achieved by using the provided 1/2” spacers between the diode
and the bottom of the cabinet (see Figure 7). The amount of rotation depends on your lis-
tening position.
Set the rotation as follows:
1. Using provided 3/16 Allen wrench, remove the back two setscrews from the
bottom of the Center channel. Insert the spike with nut in their place. Turn
to Section 10, table 1, locate your listening position on the table.
2. Assemble the front spikes with the listed diode/spacer combination in Table
1 (see also Figure 7).
S E C T I O N 4 . 4 — S E T U P # 1 C E N T E R C H A N N E L O N F L O O RW A T C H C E N T E R C H A N N E L S E R I E S 3 O W N E R ’ S M A N U A L
44 45
Wilson Audio Specialties
Wilson Audio Specialties