Instruction Manual

ManualsBrandsWilson Audio ManualsAudioWATCH Center Series 3

Note: Do not overtighten the bolts; a snug fit is all that is required to secure the Center

Channel to the stand.

5. Turn to Section 4.8 for final assembly instructions.

Section 4.6—Set Up #3 Center on Custom Stand or Shelf

The WATCH Center Series 3 is a non-shielded speaker and therefore, should NOT be

placed near a CRT television. However, the Center channel can be placed near plasma or

LCD televisions.

We recommend that you have a custom shelf built that allows the Center channel to

be bolted securely above the screen and rotated down toward the listening position. Sec-

tion 11 contains the requirements for this bracket. The speaker should be rotated so that

the midrange drivers are firing just below the listening position. Once you have made and

mounted the custom bracket, setup the Center channel as follows:

1. Lay the Center channel onto its side.

2. Using the provided 3/16 Allen wrench, back out the 4 setscrews from the

bottom of the Center channel to the desired length.

Note: Be sure that the Allen key end of the setscrew is facing out.

3. Carefully lift the Center channel and set the threaded setscrews into the 4

mounting holes located on the top of the mounted custom shelf.

FI GU RE 12 – BO LTING T HE CE NT ER CH ANNEL TO T HE STAN D

AN CH OR BO LT

SET SCREW 4 PLACES

ALLEN KEY END OF SET SCREW

FI GU RE 13 – LO CATING TH E SET SCRE WS

S E C T I O N 4 . 6 — S E T U P # 3 C E N T E R O N C U S T O M S T A N D O R S H E L FW A T C H C E N T E R C H A N N E L S E R I E S 3 O W N E R ’ S M A N U A L

48 49

Wilson Audio Specialties