Instruction Manual

4. Using the provided 3/8 – 16 nut, bolt the Center channel to the mounting
bracket.
5. Turn to Section 4.8 for final assembly instructions.
Section 4.7—Setup #4 Center Mounted to Ceiling
Note: Wilson Audio does not provide additional hardware for the optional ceiling mount
location of the Center channel. The Wilson customer choosing this option will need to
obtain hardware him or herself.
The Center channel has four 3/8-16 threaded holes on the bottom of the speaker.
These holes can be used to bolt the Center channel to a custom made bracket (not provid-
ed) that is attached to the ceiling. Please see Section 11 for the requirements of this custom
bracket. The hardware used to install the Center channel on its custom ceiling mount is not
provided by Wilson Audio. Once the bracket is made and mounted, follow these instruc-
tions to bolt the Center channel to the ceiling as follows:
1. Set the Center channel on the floor.
2. Using the provided 3/16 Allen wrench, remove the 4 setscrews from the bot-
tom of the Center channel.
3. Lay the Center channel onto its side and screw the four 3 inch setscrews 1
inch into the threaded holes on the bottom of the speaker.
Note: Be sure that the Allen key end of the setscrew is facing out when screwing it into
the enclosure. This will allow for easy installation and removal in the future.
4. Using the 5/32” Allen wrench, remove the 2 midrange drivers. Do not unsol-
der the leads (see Figure 13).
HEX KEY END OF
SETSCREW
3/8 – 16 NUT AND LOCK WASHER.
TIGHTEN UNTIL SNUG
FI GU RE 15 – IN STALLIN G NUT A ND LO CK WAS HE R F RO M THE INSI DE
3/8 – 16 NUT AND LOCK WASHER.
MIDRANGE DRIVERS
FI GU RE 14 – MO UN TING CENTE R CHA NN EL TO CEIL ING
S E C T I O N 4 . 7 — S E T U P # 4 C E N T E R M O U N T E D T O C E I L I N GW A T C H C E N T E R C H A N N E L S E R I E S 3 O W N E R ’ S M A N U A L
50 51
Wilson Audio Specialties
Wilson Audio Specialties