Instruction Manual

Center channel is not operating:

Driver out or not playing after connections

have been verified:

Amplifier shuts off as soon as it is turned

on:

Check the interconnects from the

source.

Check the connections on the speak-

er cables, both at the amplifier and

speaker ends. Watch especially for

connectors touching each other.

If you have found a driver with no

output, turn off your amp and dis-

connect the speaker cable. Remove

the access panel on the rear of the

enclosure. Note: The enclosures is

quite heavy. Please use care when

moving.

Using the appropriate Allen key,

open the door on the back.

You will find some resistor connec-

tions. Replace the resistor with the

supplied matching resistor. Tight-

en the new resistor in the old one’s

place.

Note: Use only Wilson Audio re-

placement resistors in your WATCH

Center. These resistors were care-

fully chosen for the overall sonic

and thermal performance.

Plug your amplifier into the wall and

turn it on.

Listen to the Center at a low level.

The driver should now be operating

correctly.

Section 7.1—Troubleshooting:

S E C T I O N 7 . 1 — T R O U B L E S H O O T I N G :W A T C H C E N T E R C H A N N E L S E R I E S 3 O W N E R ’ S M A N U A L

76 77

Wilson Audio Specialties