User's Manual

11
12
Contact Wilson Electronics Technical Support Team with any questions at 866-294-1660
or email: [e-mail]. Hours: 7 am to 6 pm MST.
During installation mode the Signal Booster is resetting itself very
quickly to aid the installer. The Signal Booster is equipped with two
indicator lights. For the first 15 minutes that the booster is plugged
in, it is programed for a test and alignment period. During this
time, the two lights will do one of the following 4 things:
1. BLINKING GREEN
If the Signal Booster lights are blinking green, the Signal Booster
is operating properly. If you are happy with the coverage area in
your building, then you are done. Blinking will stop after the 15
minute installation period.
2. BLINKING ORANGE
If an indicator light on the Signal Booster is blinking orange, the
Signal Booster is experiencing receiver overload. The Signal
Booster has protection shut off circuits to prevent the disruption
of cell towers. If the uplink indicator light is blinking orange, this
indicates that the booster has shut down due to close proximity
to a cell tower. First, turn down the gain control knob on the
uplink until you get a blinking green light. The booster is now
working with reduced gain. If the gain is not adequate for good
coverage, you will need to turn the uplink gain to maximum
and then turn the outside antenna away from the cell tower
until the uplink light turns to blinking green. If the booster will
not respond turn the gain down 5 dB and move the outside
Understanding the Signal Booster Lights and
Troubleshooting
Note: If after the initial 15 minutes you are not done with the
installation, the Signal Booster can be reset and enter installation
mode again by disconnecting and reconnecting the power supply
from the booster.