User's Manual

9
Contact Wilson Electronics Technical Support Team with any questions at 866-294-1660
or email: [e-mail]. Hours: 7 am to 6 pm MST.
10
Installing a Wilson Electronics Signal Booster
Select a location to install the Signal Booster that is away from
excessive heat, direct sunlight, moisture and that has proper
ventilation. Do not place the Signal Booster in an air-tight
enclosure. Recommended installation locations for in-building
Signal Boosters are near a power outlet and in a closet, or on
a shelf. Note: It is important to have adequate air ventilation.
Maintain at least 6 inches of clearance from surrounding objects.
Run the Outside Antenna cable to the Signal Booster and attach it
to the connector labeled “Outside Antenna” on the Signal Booster.
Run the Inside Antenna cable to the Signal Booster and attach it
to the connector labeled “Inside Antenna” on the Signal Booster.
Note: For distances of 20 feet or more, use Wilson low loss cable
to prevent significant signal loss. Note: Be careful when plugging
the connector in so as not to damage the center pins on the
connectors.
Powering up a Wilson Electronics
Signal Booster
1. Never point the front of a Directional Outside Antenna toward the
Inside Antenna. See Figures 1 & 2 on page 12.
2. Ensure that both the Outside Antenna cable and the Inside
Antenna cable are connected to the Signal Booster and the
connections are tight before powering up the Signal Booster.
3. Plug the power supply into the Signal Booster input marked “6V
DC” (carefully, to avoid damaging the center pin) and then into a
wall outlet.
4. If the Signal Booster does not have a green light please see
pages 13 & 14.
5. Using multiple Signal Boosters in one installation could cause
interference to the cell tower.