User's Manual

9
10
Contact Wilson Electronics Technical Support Team with any questions at 866-294-1660
or email: [e-mail]. Mon. -Fri. Hours: 7 am to 6 pm MST.
Point antennas away from each other
Signal Booster
Outdoor
Antenna
Inside Panel
Antenna
Inside Panel
Antenna
Figure 1
Figure 2
CORRECT INSTALLATION
During installation mode the Signal Booster is resetting itself very quickly
to aid the installer. The Signal Booster is equipped with one indicator
light. For the first 15 minutes that the Signal Booster is plugged in, it is
programmed for a test and alignment period. During this time, the light
will do one of the following 4 things:
Understanding the Signal Booster Light and
Troubleshooting
Note: If after the initial 15 minutes you
are not done with the installation, the
Signal Booster can be reset and enter
installation mode again by disconnecting
and reconnecting the power supply from
the Signal Booster.
Note: This Signal Booster is supplied with
separate uplink (UL) and downlink (DL)
gain controls. If the UL gain is reduced,
it may be necessary to reduce the DL
gain control. Some cell systems require
a balanced gain in both UL and DL for
proper operation. Reducing DL gain will
reduce coverage in the building.
1. BLINKING GREEN
If the Signal Booster is blinking green, the Signal Booster is operating
properly. If you are happy with the coverage area in your building,
then you are done. Blinking will stop after the 15 minute installation
period. If you require increased coverage area, set both gain controls to
maximum.
Outdoor
Antenna
Signal Booster
Never point antennas toward each other
INCORRECT INSTALLATION