User's Manual

7
Installing a Wilson Amplifi er
Select a location to install the amplifi er that is away from excessive heat, direct
sunlight, moisture and that has proper ventilation. Do not place the amplifi er in
an air-tight enclosure.
Recommended installation locations for in-building amplifi ers are:
• On a wall
• On the ceiling
• Near a power outlet
Run the outside antenna cable to the amplifi er and attach it to the N-Female
connector labeled “outside antenna” on the amplifi er. Run the inside antenna
cable to the amplifi er and attach it to the N-Female connector labeled “inside
antenna” on the amplifi er.
Note: Be careful when plugging the connector in so as not to damage the center
pins on the connectors.
Connect the outside antenna to the amplifi er with 9913 or equivalent coax cable
(available from Wilson Electronics). Place the inside antenna in the center of
the area needing the amplifi ed signal. It is important to have at least 75 feet of
separation between the inside and outside antennas.
AC/DC
Power Supply
Amplifier
Supports
Multiple
Users
Inside Antenna
Optional Dome
Antenna Shown
Point Yagi antenna
away from inside
antenna
Outside
Antenna
Yagi Antenna
Shown
75 feet minimum
separation between inside
and outside antenna
Antenna Separation
Warning: Connecting the
amplifi er directly to the cell phone
with use of an adapter will damage
the cell phone.
!