User's Manual

8
Powering up a Wilson Amplifi er
1.
IMPORTANT! Ensure that all cell phones and cellular data cards within 50 feet
of the inside antenna are turned off.
2. To verify proper installation of the amplifi er and antennas, make sure that the
distance between the inside and outside antennas is a minimum of 75 feet.
3. If you are using an outside Yagi antenna, never point the front of the Yagi
toward the inside antenna.
4. Ensure that both the outside antenna coax cable and the inside antenna coax
cable are connected to the amplifi er before powering up the amplifi er.
5. Plug the 6-volt power supply into the amplifi er input marked “power” (carefully,
to avoid damaging the center pin) and then into a wall outlet.
Warning: Verify that both the
outside antenna and the inside
antenna are connected to the amplifi er
before powering up the amplifi er.
!
Warning: Use only the power
supply provided in this package.
Use of a non-Wilson product may
damage your equipment.
!
NOTE: The aluminum casing of a Wilson amplifi er will adjust very quickly to the
ambient temperature of its environment. For example, in the summer, when
the attic of a house can easily exceed 100 degrees Fahrenheit, the amplifi er
temperature may be 10 or more degrees higher. The casing will be hot to the
touch. Such high temperatures will not damage the amplifi er, nor do they pose
a fi re risk. As recommended in these instructions, install the amplifi er in a
location with adequate ventilation. Keep the area free of items that could block
air fl ow to the amplifi er.