User's Manual

11
Contact Wilson Electronics Technical Support Team with any questions at 866-294-1660
or email: [e-mail]. Hours: 7 am to 6 pm MST.
12
Powering up a Wilson Electronics
Signal Booster
1. Never point the front of a directional Outside Antenna toward the inside
antenna. See Figures 1 & 2 on page 10.
2. Ensure that both the outside antenna cable and the inside antenna
cable are connected to the Signal Booster and the connections are
tight before powering up the Signal Booster.
3. Plug the 6-volt power supply into the Signal Booster input marked “6V
DC” (carefully, to avoid damaging the center pin) and then into a wall
outlet.
4. If the Signal Booster does not have a green light, please see pages
12-14.
5. Using multiple Signal Boosters in one installation could cause
interference to the cell tower.
6. Contact Wilson Electronics Technical Support Team with any questions at
866-294-1660 or email [e-mail]. Technical Support
hours are 7 am to 6 pm MST.
Channel Select Directions
Note: For a list of channel options see tables on page 18.
If you know your desired channel setting, press or hold down the 1.
yellow CH Select button until that channel is displayed on the LCD
screen. See page 12 for further instructions about the LCD screen
display numbers.
If you do not know your channel setting: 2.
Option 1: Watch the signal strength on your phone inside
the building. (To put your phone in test mode visit
www.WilsonElectronics.com or call Wilson Electronics Technical
Support Team at 866-294-1660.) This allows you to read the signal
strength from the cell tower. Press the yellow CH Select button until
you have the best signal. See page 5 & 6 on how to read the signal
strength from the cell tower.
Option 2: You may also contact your wireless service provider for
optimal channel setting information.