User's Manual

11
12
Contact Wilson Electronics Technical Support Team with any questions at 866-294-1660
or email: [e-mail]. Hours: 7 am to 6 pm MST.
During installation mode the Signal Booster is resetting itself very quickly
to aid the installer. The Signal Booster is equipped with one indicator light.
For the first 15 minutes that the booster is plugged in, it is programed for
a test and alignment period. During this time, the light and the LCD will do
one of the following 5 things:
Understanding the Signal Booster Light,
LCD Screen and Troubleshooting
Downlink
Uplink
GAIN
CNTL
Max
Min
GAIN
CNTL
Max
Min
800
CH
Select
The Uplink (UL)/Downlink (DL) gain 1.
is displayed on LCD screen above
the knobs. Turn knob to adjust. See
page 14 for Overload information.
The yellow CH Select (Channel) 2.
button will select the channel.
The Uplink (UL) knob limits only the 3.
uplink gain, whereas the Downlink
(DL) knob limits both the uplink and
the downlink gain.
You will typically adjust only the 4.
downlink knob.
If the Signal Booster is operating 5.
normally the LCD Screen will appear as shown in Figure 3.
LCD, Uplink & Downlink Directions
800
Figure 3
Note: If after the initial 15 minutes you are not done with the
installation, the Signal Booster can be reset and enter installation mode
again by disconnecting and reconnecting the power supply from the
booster.
Uplink Gain (dB)
Downlink Gain (dB)
Channel