User's Manual

13
Contact Wilson Electronics Technical Support Team with any questions at 866-294-1660
or email: [e-mail]. Hours: 7 am to 6 pm MST.
14
1. BLINKING GREEN
If the Signal Booster is blinking green, the Signal Booster is operating
properly. If you are happy with the coverage area in your building, then
you are done. Blinking will stop after the 15 minute installation period.
2. LCD SCREEN OVERLOAD
If the LCD screen shows “OVERLOAD,” see Figure 4, the Signal
Booster has automatically reduced
gain to protect a nearby cell tower.
First turn downlink (DL) gain control
knob until the “OVERLOAD” is
replaced with “UL CH DL” see Figure
5. The booster is now working with
reduced gain. If the gain is not
adequate for good coverage, you will
need to turn the gain to maximum
and then turn the outside antenna
away from the cell tower until the
“OVERLOAD” is replaced with “UL
CH DL” see Figure 5. If the booster
will not respond, turn the gain down
5 dB and move the outside antenna
position until the “OVERLOAD” is
replaced with “UL CH DL” see Figure 5.
3. BLINKING ORANGE
If the light on the Signal Booster is blinking orange the Signal Booster
is experiencing receiver overload. The Signal Booster has protection
shut off circuits to prevent the disruption of cell towers. If the light is
blinking orange, this indicates that the booster has shut down due to
close proximity to a cell tower. First, turn down the downlink (DL) gain
control until you get a blinking green light. The booster is now working
with reduced gain. If the gain is not adequate for good coverage,
you will need to turn the gain to maximum and then turn the outside
antenna away from the cell tower until the light turns to blinking green.
If the booster will not respond, turn the gain down 5 dB and move
the outside antenna. Continue to adjust the gain and the antenna
position until the light turns blinking green. Contact Wilson Electronics
Technical Support Team for assistance: 866-294-1660.