User's Manual

13
14
Contact Wilson Electronics Technical Support Team with any questions at 866-294-1660
or email: tech@wilsonelectronics.com. Hours: 7 am to 6 pm MST.
4. SOLID RED
If the light on the Signal Booster is solid red, this indicates that
the Signal Booster has shut down on that frequency to prevent an
oscillation (feedback). First, make sure that all the connections are
tight. Then reduce the gain of the booster in small increments by
rotating the downlink (DL) gain control, counter clockwise, waiting 5
seconds between each adjustment for the booster to reset. Continue
this adjustment until the light turns blinking or solid green. When
you are turning down the gain, you are reducing the inside coverage
area. If the amount of coverage area is sufficient for your needs and
the light is green, the installation is complete. If the coverage area is
not large enough, it is necessary to increase the separation distance
of the antennas by moving them horizontally or vertically farther
apart, or both. Then increase the gain until the red light comes on,
and then slightly keep decreasing the gain until the green or blinking
green light appears. If after separating the antennas your coverage
area is still too small, contact Wilson Electronics Technical Support
Team for assistance: 866-294-1660.
Note: Reduce the downlink gain if the phone shows good signal
strength but can not make calls. This happens when the separation
between the uplink and downlink gains is too much.
If your installation takes longer than 15 minutes, it is possible to re-
enter the installation mode by disconnecting and reconnecting the
power supply from the Signal Booster.
5. SOLID GREEN
The indicator light on the Signal Booster will be a solid green after
the first 15 minute installation period, if the unit is powered up and
working properly.