User's Manual

1
2
Contact Wilson Electronics Technical Support Team with any questions at 866-294-1660
or email: [e-mail]. Hours: 7 am to 6 pm MST.
Select a location to install the Signal Booster that is away from 1.
excessive heat, direct sunlight, moisture and has proper ventilation. Do
not place the Signal Booster in an air-tight enclosure.
Select a location on the roof of the building to install the Outside Antenna. 2.
Use a cell phone in test mode to find the strongest signal from the cell tower.
See page 5. Visit www.WilsonElectronics.com to find the test mode function
for your particular cell phone.
Run the Outside Antenna cable to the Signal Booster and attach it to the 3.
connector labeled “Outside Antenna” on the Signal Booster. Run the Inside
Antenna cable to the Signal Booster and attach it to the connector labeled
“Inside Antenna” on the Signal Booster. See page 8 for more information on
running cable. Lightning Surge Protection is recommended for all in-building
installations see page 7.
Select a location for the Inside Antenna, preferably in the center of 4.
where the signal needs to be amplified. A minimum separation distance
of 20 vertical (within the null zone) or 50 horizontal feet is necessary
for proper operation. If the inside coverage is not sufficient you may
need to increase the separation distance even further (see installation
diagram on pages 3 & 4).
Before powering up the Signal Booster, verify that both the Outside 5.
Antenna and the Inside Antenna are connected and check that all
connections are tight. See page 9. Note: Be careful when plugging the
connectors in so as not to bend the center pins on the connectors.
Press yellow “CH Select” button to desired setting. Your channel will 6.
show on the LCD screen. See page 11-12.
The Signal Booster has been packaged with the gain control knobs 7.
adjusted to the highest gain position. If light is not green, please refer to
pages 12-14.
Quick Install Overview
See Installation Diagram on page 3. Contact Wilson Electronics Technical
Support Team with any questions at 866-294-1660.
Warning: Connecting the Signal Booster directly to a cell phone with
use of an adapter will damage the cell phone and/or the
Signal Booster.
Wilson
®
Electronics recommends that all AC power
supplies for home electronics be plugged into a
Surge Protector Power Strip.