User's Manual

7
Contact Wilson Electronics Technical Support Team with any questions at 866-294-1660
or email: [e-mail]. Hours: 7 am to 6 pm MST.
8
Cell Tower
Drip hole on bottom
Installing Lightning Protection (sold separately)
Outside Antenna Installation
The antenna should be mounted as shown in the illustration above.
The mounting bracket, included with antenna, is adjustable and will
accommodate pipe diameters from 1.25” to 2” (pipe sold separately).
Mount the antenna so that there is at least 3 feet of clearance in all
directions around it. Position the antenna so that it has an unobstructed
line of sight to the cell tower’s strongest signal. Make sure the antenna
is not pointing across your own roof or at the Inside Antenna as this will
cause the oscillation protection circuitry to shut down the Signal Booster.
Warning: Lightning protection is recommended for all installations
(Part #859902-50 Ohm shown below or 859988-75 Ohm). Take
extreme care to ensure that neither you nor the antenna comes
near any electric power lines.
Install the Lightning Surge
Protector (LSP) close to
the Signal Booster. Attach
the cable from the Outside
Antenna to the surge protector,
using a short length of low
loss cable; attach one end to
the LSP and the other to the
Outside Antenna connector
on the Signal Booster. Ensure
the LSP is properly grounded
(ground wire not included).
LSP sold separately, go to
www.WilsonElectronics.com or
call 800-204-4104 to order.
To the outside antenna
Ground Wire
Lightning Surge
Protection
Signal Booster
(not included)