User's Manual

1
2
Contact Wilson Electronics Technical Support Team with any questions at 866-294-1660
or email: tech@wilsonelectronics.com. Mon.- Fri. Hours: 7 am to 6 pm MST.
NOTE: The cell phone must be placed in the cradle to work properly.
NOTE: See the Warnings section for additional information.
Warning: DO NOT use phone covers that have chrome or any other metallic surface. It may block
cellular signals.
Vehicle Installation
1. Install the Outside Antenna
To receive the best cell signal, select a location for the Outside Antenna that is preferably in the center of
the vehicle’s roof, 12 inches away from any other antennas, free of obstructions, and at least 6 inches from
the rear and side windows or sunroof.
How it Works
With the phone in the cradle and while using a wireless Bluetooth
®
headset (or hands free device) the
Outside Antenna collects the cell tower signal and sends it through the cable to the Sleek 4G. The signal
is then boosted by the Sleek 4G and sent to the phone. When the phone transmits, the signal is picked
up wirelessly and boosted by the Sleek 4G and transmitted back to the cell tower through the Outside
Antenna.
The Outside Antenna must be installed vertically. Antenna performance will be degraded if the antenna is
not vertical. The antenna cable is small yet strong enough that it may be shut in most vehicle doors without
damaging the cable.
NOTE: For a more professional looking
installation, run the antenna cable under
the door seal. Carefully pull down the
door seal. Run the cable under the seal
and push the seal back into place. This
prevents constant wear and tear on the
cable as the door opens and closes.
The antenna cable is small enough to
easily tuck under the door seal or plastic
molding.
Sleek 4G
w/phone
Sleek 4G w/phone
Outside Antenna
communicates with cell tower
Sleek 4G boosts
signal to and
from cell tower