User's Manual

Wilson
®
Electronics, Inc. Phone: [phone] Fax: [phone] - www.wilsonelectronics.com
30-Day Money-Back Guarantee
All Wilson Electronics products are protected by Wilson’s 30-day money-back guarantee. If, for any reason, the performance of any product is not acceptable, simply return
the product directly to the reseller with a dated proof of purchase.
1-Year Warranty
Wilson Electronics amplifi ers are warranted for one (1) year against defects in workmanship and / or materials. Warranty issues may be resolved by returning the
product directly to the reseller with a dated proof of purchase.
Amplifi ers may also be returned directly to the manufacturer at the consumer’s expense, with a dated proof of purchase and a Returned Material Authorization (RMA)
number supplied by Wilson Electronics. Wilson shall, at its option, either repair or replace the product. Wilson Electronics will pay for delivery of the repaired or replaced
product back to the original consumer within the continental United States.
This warranty does not apply to any amplifi ers determined by Wilson Electronics to have been subjected to misuse, abuse, neglect, or mishandling that alters or
damages physical or electronic properties.
RMA numbers may be obtained by phoning Technical Support at 866-294-1660.
Operation is subject to the following two conditions: (1) This device may not cause interference, and (2) this device must accept any interference, including
interference that may cause undesired operation of this device.
Disclaimer: The information provided by Wilson Electronics, Inc. is believed to be complete and accurate. However, no responsibility is assumed by Wilson
Electronics, Inc. for any business or personal losses arising from its use, or for any infringements of patents or other rights of third parties that may result from its
use.Copyright © 2008 Wilson Electronics, Inc. All rights reserved.
#110788 -U-Booster™ Install Guide 2B5225 / 04.06.10
Amplifi er Specifi cations
Dual Band
800/1900 MHz Specifi cations
Model Number / Part Number 2B5225/805225
Connectors SMA Female
Impedance (input/output) 50 ohms
Frequency 824-894 MHz / 1850-1990 MHz
1
Passband Gain (nominal)
20 dB (typical) / 30 dB (maximum)
2
20 dB Bandwidth (nominal)
800 MHz (uplink/downlink) 43 MHz / 45 MHz
1900 MHz (uplink/downlink) 112 MHz / 84 MHz
Power output for single cell phone (uplink) 800 MHz 1900 MHz
CDMA 28.9 dBm 31.8 dBm
GSM 30.9 dBm 32.6 dBm
EDGE 30.9 dBm 31.9 dBm
WCDMA 30.13 dBm 31.4 dBm
3,4
Power output (uplink) for multiple
cell phones:
Number of
cell phones
Maximum Power
3
800 MHz 1900 MHz
2 27.3 dBm 21.5 dBm
3 23.8 dBm 18.0 dBm
4 21.3 dBm 15.5 dBm
5 19.3 dBm 13.5 dBm
6 17.8 dBm 12.0 dBm
Power output for single received channel (downlink) 800 MHz 1900 MHz
CDMA -.9 dBm 1.0 dBm
GSM -1.3 dBm 1.8 dBm
EDGE -1.3 dBm 2.1 dBm
WCDMA .32 dBm 2.3 dBm
3,4
Power output for multiple
received channels (downlink). The
maximum power is reduced by the
number of channels:
Number of
channels
Maximum Power
3
800 MHz 1900 MHz
2 -1.1 dBm 2.2 dBm
3 -4.7 dBm -1.4 dBm
4 -7.2 dBm -3.9 dBm
5 -9.1 dBm -5.8 dBm
6 --10.7 dBm -7.4 dBm
Noise Figure (typical) 3 dB nominal
Isolation > 40 dB
Power Requirements
5V DC, 1A
Notes:
1. Nominal gain is the maximum gain at any frequency in the passband.
2. Nominal bandwidth is the difference between two frequencies that are adjacent to the passband where the amplifi cation is 20 dB
lower than the passband amplifi cation. One of the frequencies is lower than the passband and the other is higher.
3. The Manufacturer’s rated output power of this equipment is for single carrier operation. For situations when multiple carrier
signals are present, the rating would have to be reduced by 3.5 dB, especially where the output signal is re-radiated and can
cause interference to adjacent band users. This power reduction is to be by means of input power or gain reduction and not by
an attenuator at the output of the device.
4. The maximum power for 2 or more simultaneous signals will be reduced by 6 dB every time the number of signals is doubled.