User's Manual

2
Contact Wilson Electronics’s Technical Support Team with any questions at 866-294-1660
Or email: [e-mail] Mon.- Fri. Hours: 7am to 6 pm MST.
Warning: In a wireless installation, do not
plug the Signal Booster directly into the cell
phone and/or data card using an antenna
adapter. It may damage the Signal Booster,
cell phone and/or data card.
!
!
Quick Installation Overview
Magnet - Mount
Antenna Shown
Part #301103
Carefully
Pull Down
Door Seal
Run Cable
Under Seal
Tuck Cable
Under Seal
Installing the Outside Antenna
To receive the best cell signal, select a location in the
center of the vehicle’s roof 12 inches away from any other
antennas or windows. If the vehicle has a sunroof, it is
important to separate the Inside and Outside Antennas by
at least five feet. This prevents the Signal Booster from
overloading or oscillating. As shown above. Follow the
specific antenna installation instructions included with the
Outside Antenna.
Separation of the Inside and Outside Antennas is very
important. The metal roof of the vehicle acts as a barrier
and helps shield the two antennas from each other,
preventing oscillation (feedback).
The Outside Antenna must be installed vertically. Signal
performance will be degraded if the antenna is not vertical.
The antenna cable may run through the door to the Signal
Booster.
For a more professional looking installation, run the
antenna cable under the door seal. The antenna cable is
small enough to easily tuck under the door seal or plastic
molding. Carefully pull down the door seal. Run the cable
through the seal and push the seal back into place. This
prevents constant wear and tear on the cable as the door
opens and closes.
Warning: Do not plug in the DC power
supply until the Outside and Inside
Antenna cables are attached to the Signal
Booster.
HUMMER HUMMER
Installation Diagram
Outside
Antenna
Inside
Antenna
Distance between antennas
through a sunroof must be 5
feet or more.
DC Power
Supply
Signal
Booster
Cell Phone
PDA
Notebook
Before Getting Started
This guide will help you properly install your Wilson Electronics Dual-Band Mobile Wireless Signal
Booster. It is important to read through all of the installation steps for your particular application
prior to installing any equipment. Read through the instructions, visualize where all the equipment
will need to be installed and do a soft installation before mounting any equipment. Contact Wilson
Electronics Technical Support Team with any questions at 866-294-1660.