User's Manual

Signal Booster Specifications
Dual Band Specifications
Model Number 460002
Connectors FME
Impedance (input/output) 50 ohms
Dimensions 5.6 x 3.6 x 1.7 inch or 14.2 x 9.1 x 4.4 cm
Weight 1.2 lbs or 0.54 kg
Frequency 824-894 MHz / 1850-1990 MHz
1
Passband Gain (nominal) 800 MHz 1900 MHz
47.8 dB 43.8 dB
2
20 dB Bandwidth (nominal) Typical Maximum
800 MHz (uplink/downlink) 41.1 42.9
1900 MHz (uplink/downlink) 76.1 76.5
Power output for single cell phone (uplink) dBm 800 MHz 1900 MHz
23.4 23.4
Power output for single cell phone (downlink) dBm 800 MHz 1900 MHz
-3.1 -0.9
3
Power output (uplink) for multiple
cell phones:
No. Tones
Maximum Power
800 MHz 1900 MHz
2 23.3 18.0
3 19.8 14.5
4 17.3 12.0
5 15.3 10.1
6 13.7 8.5
4
Power output for multiple received
channels (downlink).
No. Tones
Maximum Power
800 MHz 1900 MHz
2 -1.4 2.5
3 -4.9 -1.0
4 -7.9 -3.5
5 -9.3 -5.4
6 -10.9 -7.0
Noise Figure (typical) 3 dB nominal
Isolation > 90 dB
Power Requirements
Signal Booster Usage
6 V, 0.5 A - 1.5 A (subject to uplink power)
The Manufacturer’s rated output power of this equipment is for single carrier operation. For situations when multiple
carrier signals are present, the rating would have to be reduced by 3.5 dB, especially where the output signal is re-
radiated and can cause interference to adjacent band users. This power reduction is to be by means of input power or
gain reduction and not by an attenuator at the output of the device.
111256_Rev01_01.16.14