Installation Guide

IN-BUILDING CELL SIGNAL AMPLIFIER ENTERPRISE 4300 & 4300R

Warnings

To uphold compliance with network protection standards, all active cellular devices must maintain at

least 6 feet of separation distance from Panel and Dome antennas.

Use only the power supply provided in this package. Use of a non-Wilson Electronics product may

damage your equipment.

The Signal Ampliﬁer unit is designed for use in an indoor, temperature-controlled environment

(operating temperature ranges from -40°C to 60°C – -40°F to 140°F). It is not intended for use in attics

or similar locations subject to temperatures in excess of that range.

RF Safety Warning: Any antenna used with this device must be located at least 8 inches from all persons.

AWS Warning: The Outside Antenna must be installed no higher than 10 meters (31’9”) above ground.

This is a CONSUMER device.

BEFORE USE, you MUST REGISTER THIS DEVICE with your wireless provider and have

your provider’s consent. Most wireless providers consent to the use of signal boosters.

Some providers may not consent to the use of this device on their network. If you are

unsure, contact your provider.

In Canada, BEFORE USE you must meet all requirements set out in ISED CPC-2-1-05.

You MUST operate this device with approved antennas and cables as speciﬁed by the

manufacturer. Antennas MUST be installed at least 20 cm (8 inches) from (i.e., MUST NOT

be installed within 20 cm of) any person.

You MUST cease operating this device immediately if requested by the FCC (or ISED in

Canada) or licensed wireless service provider.

WARNING. E911 location information may not be provided or may be inaccurate for calls

served by using this device.

This device may be operated ONLY in a ﬁxed location (i.e..may operate in a ﬁxed location

only) for in-building use.

FOR MORE INFORMATION ON REGISTERING YOUR SIGNAL BOOSTER WITH YOUR

WIRELESS PROVIDER, PLEASE SEE BELOW:

Sprint: http://www.sprint.com/legal/fcc_boosters.html

T-Mobile/MetroPCS: https://support.t-mobile.com/docs/DOC-9827

Verizon Wireless: http://www.verizonwireless.com/wcms/consumer/register-signal-booster.html

AT&T: https://securec45.securewebsession.com/attsignalbooster.com/

U.S. Cellular: http://www.uscellular.com/uscellular/support/fcc-booster-registration.jsp

FOR MORE INFORMATION ON REQUIREMENTS SET OUT IN ISED CPC-2-1-05,

SEE BELOW:

http://www.ic.gc.ca/eic/site/smt-gst.nsf/eng/sf08942.html

Safety Guidelines