Installation Guide

IN-BUILDING CELL SIGNAL AMPLIFIER ENTERPRISE 4300 & 4300R
18
Model Number 460152 / 460152F / 460153 / 460153F
FCC ID
PWO460052 / PWO460052 / PWO460053 / PWO460053
IC ID
4726A-460052 / 4726A-460052 / 4726A-460053 / 4726A-460053
Connectors N-Connectors
Antenna Impedance 50 Ohms
Frequency
698-716 MHz, 729-756 MHz, 777-787 MHz, 824-894 MHz, 1850-1995 MHz, 1710-1755/2110-2155 MHz
Power output for single cell
phone (Uplink) dBm
700MHz Band12/17 700MHz Band13 800MHz 1700MHz 1900MHz
22.9 23.1 24.6 22.8 25.5
Power output for single cell
phone (Downlink) dBm
700MHz Band12/17 700MHz Band13 800MHz 2100MHz 1900MHz
16.9 16.7 16.8 16.6 16.6
Noise Figure 5 dB nominal
Isolation > 90 dB
Power Requirements
120V AC 0.5A
The term “IC” before the radio certification number only signifies that Industry Canada technical specifications were met.
Each Signal Booster is individually tested and factory set to ensure FCC compliance. The Signal Booster cannot be adjusted without
factory reprogramming or disabling the hardware. The Signal Booster will amplify, but not alter incoming and outgoing signals in order
to increase coverage of authorized frequency bands only. If the Signal Booster is not in use for five minutes, it will reduce gain until a
signal is detected. If a detected signal is too high in a frequency band, or if the Signal Booster detects an oscillation, the Signal Booster
will automatically turn the power o on that band. For a detected oscillation the Signal Booster will automatically resume normal
operation after a minimum of 1 minute. After 5 (five) such automatic restarts, any problematic bands are permanently shut o until the
Signal Booster has been manually restarted by momentarily removing power from the Signal Booster. Noise power, gain, and linearity
are maintained by the Signal Booster’s microprocessor.
This device complies with Part 15 of FCC rules. Operation is subject to two conditions: (1) This device may not cause harmful interfer-
ence, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes
or modifications not expressly approved by weBoost could void the authority to operate this equipment.
Specifications
NEED HELP?
support.wilsonpro.com 866.294.1660