Specifications

3
Contact Wilson Electronics’s Technical Support Team with any questions at 866-294-1660
Or email: [e-mail] Mon.- Fri. Hours: 7am to 6 pm MST.
4
Place the Low-Profile Antenna on the side of the
driver’s seat for maximum performance.
Install the Low-Profile Antenna at least eight inches,
but not more than 12 inches, from where the cellular
device will be used.
Install the Low-Profile Antenna at the same angle
as the cell phone when held in use, or place next to
the laptop’s cellular data card. This will maximize the
signal strength.
For a more professional looking installation, the Low-
Profile Antenna may be slid under the seat cover or
upholstery, high on the driver’s seat.
Warning: Do not install the Low-Profile Antenna
within four inches of metal. (Metal found inside
the vehicle’s seat will not affect the antenna’s
performance.)
Signal Booster
Low-Profile
Antenna
Installing the Low-Profile Antenna
Installing a Wilson Electronics Signal Booster
Warning: The Inside Antenna must be installed with
a separation of at least eight inches from all persons
and must not be located in conjunction with any other
antenna or Signal Booster.
Warning: Do not plug in the DC power supply until
the Outside and Inside Antenna cables are attached
to the Signal Booster.
Run the cable from the Outside Antenna and attach
it to the connector labeled “Outside Antenna” on the
Signal Booster.
Attach the Low-Profile Antenna cable to the connector
labeled “Inside Antenna” on the Signal Booster.
!
!
!
Select a location to install the Signal Booster that is away from excessive heat, direct sunlight,
moisture and has proper ventilation.
NOTE: The aluminum casing of a Wilson Signal Booster will adjust very quickly to the ambient
temperature of its environment. For example, in the summer, when the inside of a car can reach 140
degrees Fahrenheit, the Signal Booster temperature may be 150 degrees or higher. The casing will
be hot to the touch, similar to a metal door handle or a steering wheel. Such high temperatures will
not damage the Signal Booster, nor do they pose a fire risk to the vehicle. As recommended in these
instructions, install the Signal Booster in a location with adequate ventilation, such as under the seat
or under the dashboard. Keep the area free of items that could block air flow to the Signal Booster.