Specifications

5
Contact Wilson Electronics’s Technical Support Team with any questions at 866-294-1660
Or email: [e-mail] Mon.- Fri. Hours: 7am to 6 pm MST.
6
About Wilson Electronics
Wilson Electronics, Inc. has been a leader in the wireless communications industry for over 40 years.
The company designs and manufactures Signal Boosters, antennas and related components that
significantly improve cell phone signal reception and transmission in a wide variety of applications,
both mobile, M2M and in-building.
With extensive experience in antenna and Signal Booster research and design, the company’s
engineering team uses a state-of-the-art testing laboratory, including an anechoic chamber and
network analyzers, to fine-tune antenna designs and performance. For its Signal Boosters, Wilson
Electronics uses a double electrically shielded RF enclosure and cell tower simulators for compliance
testing.
Wilson Electronics Signal Boosters feature patent-pending Smart Technology
™
that enables them
to automatically adjust their power based on cell tower requirements. By detecting and preventing
oscillation (feedback), signal overload and interference with other users, these Smart Technology ™
Signal Boosters improve network cell phone areas without compromising carrier systems.
All products are engineered and assembled in the company’s 55,000-square-foot headquarters in St.
George, Utah. Wilson Electronics has product dealers in all 50 states as well as in countries around
the world.
This device complies with Part 15 of FCC rules. Operation is subject to two conditions: (1) This device
may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation. Changes or modications not expressly
approved by Wilson Electronics could void the authority to operate this equipment.
Warnings and Recommendations
Warning: In a wireless installation, do not plug the Signal Booster directly into the cell phone or
cellular data card using an antenna adapter. It will damage the Signal Booster, cell
phone or cellular data card.
Warning: Do not plug in the DC power supply until the Outside and Inside Antenna cables are
attached to the Signal Booster.
Warning: RF Safety: The Inside Antenna must be installed with a separation of at least 8 inches
from all persons and must not be located in conjunction with any other antenna or
Signal Booster.
Warning: RF Safety: The Outside Antenna must be installed with a separation of at least 20
inches from any of the vehicle’s occupants or nearby persons and must not be located
or operating in conjunction with any other antenna or Signal Booster. All roof mount
antennas should be centrally located on the roof of the vehicle. Mirror-mount antennas
should be mounted as high above the roof line as possible and leave at least 20 inches
of separation from any persons near or around the vehicle.
Warning: Use only the power supply provided in this package. The power supply must be 6 V DC
Output.