Installation guide

3
4
Contact Wilson Electronics Technical Support Team with any questions at 866-294-1660
or email: [e-mail]. Hours: 7 am to 6 pm MST.
In-Vehicle
Installing a Wilson Electronics External Adapter
An 18-inch external adapter is required to connect the cell phone or cellular data card to
the Signal Booster. The external adapter (sold separately) is cell phone/data card-specific
and may be purchased through a local retailer. Refer to Wilson Electronics Adapter Guide
to identify the right adapter for your cell phone or cellular data card. The adapter guide is
available through a local retailer or visit www.WilsonElectronics.com. The external adapter
plugs into the included (in some kits) antenna extension cable and directly into a socket on
the cell phone or cellular data card as shown in Figure 1.
The external adapter and the included extension cable (in some kits) are long enough to
reach the Signal Booster location. This allows for ease and convenience of use.
Run the extension cable from the external adapter and attach it to the connector labeled
“Cellular Phone” on the Signal Booster.
NOTE: Depending on your
specific cell phone, the
adapter socket may be
located beneath a rubber
plug.
Figure 1
Sample Adapter
Select a location to install the Signal
Booster that is away from excessive heat,
direct sunlight, moisture and that has proper
ventilation.
Recommended installation locations for
in-vehicle are:
• Under the seat
• Under the dash
Run the cable from the outside antenna and
attach it to the connector labeled “Outside
Antenna” on the Signal Booster.
Installing a Wilson Electronics Signal Booster