Installation guide

7
8
Contact Wilson Electronics Technical Support Team with any questions at 866-294-1660
or email: tech@wilsonelectronics.com. Hours: 7 am to 6 pm MST.
Warnings and Recommendations
Warning: Verify that both the outside antenna and the adapter extension cable are
connected to the Signal Booster before powering up the Signal Booster.
Warning: RF Safety: In-vehicle - The outside antenna must be installed with a
separation of at least 16 inches from any of the vehicle’s occupants or
nearby persons and must not be located or operating in conjunction
with any other antenna or Signal Booster. Use of a cellular Signal
Booster with an antenna gain higher than 5.12 dBi is in violation of FCC
regulations, for which the offender is fully liable. All Wilson Electronics
mobile antennas are 5.12 dBi or less.
Warning: RF Exposure Compliance: In-vehicle - All roof-mount antennas should
be centrally located on the roof of the vehicle. Glass-mount antennas
should be located in the middle of either the front or back windshield.
Mirror-mount antennas should be mounted as high above the roof top as
possible and leave at least 16 inches of separation from any persons in or
around the vehicle.
Warning: RF Safety: In-Building - The outside antenna must be installed on an
outdoor permanent structure with a separation of at least 20 feet from all
persons during normal operation.
Lightning protection is recommended for all in-building installations.
NOTE: The aluminum casing of a Wilson Electronics Signal Booster will adjust very quickly
to the ambient temperature of its environment. For example, in the summer, when the
inside of a car can reach 140 degrees Fahrenheit, the Signal Booster temperature may be
150 degrees or higher. The casing will be hot to the touch, similar to a metal door handle
or a steering wheel. Such high temperatures will not damage the Signal Booster, nor do
they pose a fire risk to the vehicle. As recommended in these instructions, install the Signal
Booster in a location with adequate ventilation, such as under the seat, in the trunk or under
the dashboard. Keep the area free of items that could block air flow to the Signal Booster.