Installation guide

13
14
Contact Wilson Electronics Technical Support Team with any questions at 866-294-1660
or email: [e-mail]. Hours: 7 am to 6 pm MST.
adequate for good coverage, you will need to turn the gain
to maximum and then turn the outside antenna away from
the cell tower until the light turns to blinking green. If the
booster will not respond, turn the gain down 5 dB and move the
outside antenna. Continue to adjust the gain and the antenna
position until the light turns blinking green. Contact Wilson
Electronics Technical Support Team for assistance:
866-294-1660.
3. SOLID RED
If either of the two lights on the signal booster are solid red,
this indicates that the signal booster has shut down on that
frequency to prevent an oscillation. First, make sure that all the
connections are tight. Then reduce the gain of the booster
in small increments by rotating the gain control, counter-
clockwise, waiting 5 seconds between each adjustment
for the booster to reset. Continue this adjustment until the
light turns blinking or solid green. When you are turning
down the gain, you are reducing the inside coverage area. If
the amount of coverage area is sufficient for your needs and
the light is green the installation is complete. If the coverage
area is not large enough, it is necessary to increase the
separation distance of the antennas by moving them
horizontally or vertically farther apart, or both. Then
increase the gain until the red light comes on, and then
slightly keep decreasing the gain until the green or
blinking green light appears. If after separating the antennas
your coverage area is still too small, contact Wilson Electronics
Technical Support Team for assistance: 866-294-1660.
If your installation takes longer than 15 minutes, it is possible
to re-enter the installation mode by disconnecting and
reconnecting the power supply from the signal booster.
4. SOLID GREEN
The indicator lights on the signal booster will be a solid green
after the first 15 minute installation period and the unit is
powered up and working properly.