Owner`s manual

Note: the material used for the bottom of the Center channel Wilson’s proprietary high
density composite X-material. While very hard, X-material is easily cross threaded when
installing the spikes. Be careful that the spike thread is engaging properly into the bot-
tom.
5. Screw the 3/8-16 nut and lock washer onto the setscrew from the inside of
the enclosure (see Figure 14).
6. Tighten until snug using the open-ended wrench.
7. Replace the midrange drivers.
8. While two people hold the speaker up to the mounting bracket, a third per-
son bolts the speaker to the ceiling. Use two 3/8-16 nuts on each threaded
rod. This will lock the nuts into place.
Fi gu re 16 – MOunTi ng Cen Ter CHAn nel TO Ceil ing
uSer Made cuStOM
MOunting bracKet
center channel MOunt angleS
SpeaKer dOwn tOwardS the liStener
center channel bOltS tO bracKet via
fOur 3/8-16 bOltS and nut attached
frOM inSide the SpeaKer
W a T C H C e n T e r C H a n n e l S e r i e S 3 O W n e r ’ S m a n u a l
52
Wilson Audio Specialties