Specifications

Signal Booster Specifications
Dual Band Specifications
Model Number 460002
Connectors SMA
Impedance (input/output) 50 ohms
Dimensions 6.2 x 3.6 x 1.3 inch or 15.7 x 9.1 x 3.3 cm
Weight 1.2 lbs or 0.54 kg
Frequency 824-894 MHz / 1850-1990 MHz
Power output for single cell phone (dBm) 800 MHz 1900 MHz
Uplink 23.4 23.4
Downlink -3.1 -0.9
Noise Figure (typical) 3 dB nominal
Isolation > 90 dB
Power Requirements
Signal Booster Usage
6 V, 0.5 A - 1.5 A (subject to uplink power)
Each Signal Booster is individually tested and factory set to ensure FCC compliance. The Signal Booster cannot be adjusted without factory reprogram-
ming or disabling the hardware. The Signal Booster will amplify, but not alter the incoming and outgoing signals in order to increase coverage of
authorized frequency bands only. If the Signal Booster is not in use for five minutes, it will reduce gain until a signal is detected. If a detected signal
is too high in a frequency band, or if the Signal Booster detects and oscillation, the Signal Booster will automatically turn the power off on that band.
For a detected oscillation the Signal Booster will automatically resume normal operation after a minimum of 1 minute. After 5 (five) such restarts, any
problematic bands are permanently shut off until the Signal Booster has been manually restarted by momentarily removing the power from the Signal
Booster. Noise power, gain, and linearity are maintained by the Signal Booster’s microprocessor.
111256_Rev01_01.20.14