Installation guide

9
Contact Wilson Electronics Technical Support Team with any questions at 507-282-8484
or email: [e-mail]. Hours: 7 am to 6 pm MST.
10
Installing the Inside Antenna
Find the desired location for the panel antenna. Verify that the
panel antenna and the outside antenna have the necessary
separation (Minimum of 20 vertical/horizontal feet if installed with
signal booster set at a lower gain, for maximum gain you may
need as much as 50 feet of separation). For optimum results the
antenna should be mounted at least 6 feet off the ground.
Ceiling
Rafters
Inside
Antenna
In some cases, multiple inside antennas may be required, for
instance if you have multiple rooms with poor signal. A signal may
be split by using a splitter. If using more than one inside antenna,
a separation of at least 20 feet is necessary between inside
antennas. See configuration on pages 3 & 4.
Installing a Wilson Electronics Signal Booster
Select a location to install the signal booster that is away from
excessive heat, direct sunlight, moisture and that has proper
ventilation. Do not place the signal booster in an air-tight
enclosure. Recommended installation locations for in-building
signal boosters are:
• On a shelf
• In a closet
• Near a power outlet
Note: It is important to have adequate air ventilation. Maintain at
least 6 inches of clearance from surrounding objects.
Run the outside antenna cable to the signal booster and attach it
to the connector labeled “Outside Antenna” on the signal booster.
Run the inside antenna cable to the signal booster and attach it to
the connector labeled “Inside Antenna” on the signal booster.