Installation guide

7
Contact Wilson Electronics Technical Support Team with any questions at 507-282-8484
or email: [e-mail]. Hours: 7 am to 6 pm MST.
8
Cell Tower
Drip hole on bottom
Installing Lightning Protection
Outside Antenna Installation
The antenna should be mounted as shown in the illustration
above. The mounting bracket, included with antenna, is adjustable
and will accommodate pipe diameters from 1.25” to 2” (pipe sold
separately). Mount the antenna so that there is at least 3 feet of
clearance in all directions around it. Position the antenna so that
it has an unobstructed line of sight to the cell tower’s strongest
signal. Make sure the antenna is not pointing across your own roof
or at the inside antenna as this will cause the oscillation protection
circuitry to shut down the signal booster.
Warning: Lightning protection is recommended for all installations
(Part #859902 or 859988). Take extreme care to ensure that
neither you nor the antenna comes near any electric power lines.
Install the Lightning Surge
Protector (LSP) close to
the signal booster. Attach
the cable from the outside
antenna to the surge
protector, using a short length
of low loss cable; attach
one end to the LSP and the
other to the outside antenna
connector on the signal
booster. Attach a ground
wire to the LSP. (For AG Pro
70 use Part# 859988 75 Ohm
Lightning Surge Protector).
To the outside antenna
Ground Wire
Lightning Surge
Protection
Signal Booster